Safety and Usage Information
For indoor use only.
IMPORTANT! If you have any problems regarding the electrical installation, contact an electrician. Always shut off power to the circuit before starting installation work.
Assembly Steps
Step 1: Prepare the Lamp Body
The diagram shows the lamp structure with multiple arms. An information icon ? is displayed. Two configurations are shown: one with arms extended correctly, and one with arms crossed, marked with a ❌ symbol, indicating it is incorrect.
Hands are shown attaching the main lamp body to a base.
Step 2: Adjust Lamp Arms
Hands are shown rotating one of the lamp arms. The diagram then shows the lamp structure with one arm rotated, and a threaded socket being inserted into the end of an arm.
Step 3: Attach Socket Holders
Three (3x) circular mounting plates/washers are shown being attached to the ends of the lamp arms. Arrows indicate screwing them into place.
Step 4: Insert Light Bulbs
Three (3x) light bulbs are shown being inserted into the sockets. Arrows indicate screwing them in.
Step 5: Secure Glass Shades
Hands are shown screwing three (3x) spherical glass shades onto the threaded sockets. Arrows indicate the direction of rotation.
Step 6: Mount Ceiling Canopy
The main lamp canopy/ceiling mount is shown being attached to the ceiling. An inset shows a close-up of a screw being inserted and tightened.
Step 7: Attach Mounting Bracket
The mounting bracket with a hook (1x) is shown being attached to the ceiling canopy using screws. Electrical wires are visible.
Step 8: Connect Wires
The lamp's electrical wires are shown being connected to the ceiling wires using a connector block. The hook from the mounting bracket is shown being attached to the connector block.
Step 9: Prepare Wire Connector
A wire connector block is shown being opened. A cable is inserted, and a curved arrow indicates closing the cover.
Step 10: Insert Wires into Terminals
Wires are shown being inserted into the terminals of the connector block and pushed upwards.
Step 11: Connect Main Power
The main power cable wires, labeled 'L' (Line) and 'N' (Neutral), are shown being connected to the corresponding terminals in the connector block. Two wires (2x) are inserted into each terminal.
The connector block is shown attached to the ceiling bracket.
Step 12: Close Connector Block
The cover of the wire connector block is shown being closed. The text "Click!" indicates completion.
Step 13: Attach Lamp Body to Canopy
The main lamp body is shown being attached to the ceiling canopy. An inset shows a close-up of a screw being tightened.
Step 14: Final Shade Attachment
Hands are shown attaching the glass shades (3x) to the lamp arms, screwing them on. Arrows indicate the direction of rotation.
Parts List
- Spherical glass shades: 3x
- Threaded socket holders: 3x
- Circular mounting plates/washers: 3x
- Mounting bracket with hook: 1x
