TECWERK LED Inspection Light

Introduction

This manual provides essential information to help you get the most out of your TECWERK LED Inspection Light and avoid damage. Please read the manual completely and keep it for future reference.

Article Number: 2000 877 190

Safety Instructions

• Do not use the device if the housing, plug, or cable are damaged. Contact an authorized specialist.
• Do not open the device. Repair work and battery replacement must only be carried out by qualified electricians.
• Perform cleaning work only when the mains plug is disconnected. There is a risk of short circuit. Repairs must only be carried out by authorized and trained personnel.
• Protect the battery from heat, intense sunlight, fire, water, and moisture. There is a risk of explosion.
• If the battery is damaged or used improperly, liquids may leak. Avoid contact. Leaking battery fluids can cause skin irritation or burns. If liquid gets into your eyes, consult a doctor.
• Do not place the lamp on an illuminated surface when it is switched on.

Product Warranty Instructions

The company guarantees that products shipped from the factory meet relevant safety standards and technical requirements, functioning correctly under normal use and maintenance.

If, within one year of purchase, maintenance personnel confirm a defect due to manufacturing processes or materials, the warranty service is free.

This warranty covers material or workmanship defects but does not include:

• Product damage caused by misuse.
• Product damage caused by incorrect installation.
• Product damage caused by unauthorized customer modifications.
• Natural disasters and man-made damage.

The company provides after-sales service only with valid receipts and corresponding product warranty cards.

Do not expose the product to moisture or water.

No returns are accepted after sale, except for quality problems.

Technical Data

Operating & Charging Procedure

Operating Modes:

• Press the switch first time: Top light turns on.
• Press the switch second time: Main light switches to ECO power mode.
• Press the switch third time: Main light switches to Normal mode.
• Press the switch fourth time: Main light switches to Full power mode.
• Press the switch fifth time: All lights turn off.

Charging:

• Turn off the lamp, place it on the base, and connect it to the USB-C charger. The side charging port can be used if the charging base is not available.
• The indicator LED blinks during charging. When charging is complete, the green LED indicator lights up.
• If the battery indicator does not light up, remove the charger and try again.
• Charge the hand lamp for 4-5 hours before first use.
• Fully charge the hand lamp before storing it for a longer period.

Disposal

[recycle] Packaging, batteries, and electrical devices should not be disposed of with household waste.

As the owner, you are legally obligated to separate these materials from unsorted municipal waste and deliver them to appropriate recycling collection points.

Alternatively, you can return them to the location where you purchased the product.

Declaration of Conformity

The NORDWEST Handel AG declares in sole responsibility that the article LED-Inspection Light, article number 2000 877 190, complies with the essential requirements of the following directives and regulations: 2011/65/EU, 2014/30/EU, VO (EU) 2023/1542.

A complete declaration of conformity can be downloaded from this internet address: https://download.nordwest.com/datasheets/

Manufacturer/Distributor:

NORDWEST Handel AG
Robert-Schuman-Straße 17
44263 Dortmund, Germany
Tel. +49 231 2222-3001
info@nordwest.com
www.nordwest-tecwerk.com