SAT Brevis Wall-mounted Washbasin

This guide provides instructions for installing the SAT Brevis Wall-mounted Washbasin.

Model Numbers: SATBRE4020SL, SATBRE4020SR

Brand: SAT

Tools and Materials Required:

• Measuring tape
• Pencil
• Drill with Ø6 and Ø10 drill bits
• Screwdriver
• Wrench
• Hammer
• Spirit level
• Anchors (for brick or concrete walls only)
• Screws

Safety Precautions:

• Do not spray with water or liquids. ❌
• Avoid contact with electricity. ❌
• Do not use near open flames or heat sources. ❌
• Wear protective gloves when handling chemicals. ?
• Keep away from incompatible materials. ❌

Installation Steps:

1. Determine the desired height for the washbasin, typically between 85-90 cm from the floor.

2. Mark the wall for the mounting points based on the washbasin's dimensions and the included mounting bracket.

3. Using a Ø10 drill bit, drill holes at the marked locations for the wall anchors.

4. Insert the wall anchors into the drilled holes. If using the provided anchors, ensure they are suitable for your wall type (brick or concrete). The document advises against using these specific plugs for other wall types.

5. Attach the mounting bracket to the wall using screws and a screwdriver. Ensure it is level.

6. Align the washbasin with the mounting bracket and secure it in place. The diagram shows two brackets (2x) being attached to the washbasin, and then the washbasin being mounted.

7. Gently push the washbasin onto the mounting bracket until it clicks or is firmly seated.

8. For additional support or specific mounting configurations, further drilling with a Ø6 drill bit might be required (indicated by 4x Ø6 in the diagram).

9. The diagram shows the use of a hammer to secure anchors and a screwdriver for screws. It also reiterates that the anchors are for brick or concrete walls only.

10. The washbasin is shown being placed onto the wall bracket.

11. The final steps involve attaching any remaining components, possibly including water supply connections and waste fittings, using a wrench.

12. The washbasin is shown fully installed on the wall.

Product Information:

The SAT Brevis washbasin is a wall-mounted unit designed for modern bathrooms.

Manufactured by Swiss Aqua Technologies AG.

Website: www.swatec.ch