IRIS USA Woozoo PCF-SC15T Globe Fan User Manual
Model: PCF-SC15T
Brand: IRIS USA, Inc.
Safety Precautions
Please read these safety precautions carefully to ensure proper use. They are classified as Warnings and Cautions to prevent harm or damage.
General Warnings
⚠️ CAUTION: Indicates content that could lead to death or injury if handled incorrectly.
? PROHIBITED: Instructions that must NOT be followed.
✅ INSTRUCTIONS TO FOLLOW: Critical instructions for safe operation.
Disassembly Prohibited
- Do not disassemble, repair, or modify. This can cause fire, electric shock, or injury. Repairs should only be performed by trained technicians.
- Warning: To reduce the risk of fire or electric shock, do not use this product with any solid-state speed control device.
Product Use
- For household use only. Do not use for commercial purposes or for anything other than its intended use.
- Do not use near radios or televisions, as it may interfere with signals.
- Avoid direct sunlight or heating devices, which can cause deformation or malfunction.
- Use on a level, stable surface to prevent tipping.
- Place away from curtains or strings to prevent entanglement and damage.
- Always grasp the power plug to unplug; do not pull the cord, as this can cause damage and risk of fire or electric shock.
- Unplug when not in use for extended periods to prevent fire or shock from reduced insulation.
- The product has overload protection (fuse). If the fuse blows, unplug, replace with the correct rating (2.5Amp, 125Volt), and check for short-circuits. If it blows again, return for inspection/repair.
- Do not run the cord under carpeting, rugs, furniture, or appliances. Keep it away from high-traffic areas.
- Dispose of product and packaging according to government regulations.
Remote Use
WARNING: Chemical Burn Hazard. Do not allow batteries to be swallowed.
- This product contains a button/coin cell battery. Swallowing can cause severe internal burns and death. Keep batteries away from children.
- Secure the battery compartment. If it doesn't close securely, stop use, remove batteries, and keep away from children. Seek immediate medical attention if batteries are swallowed or placed inside the body.
- Pay attention to battery polarity symbols (+/-).
- Remove the remote battery for extended periods of non-use to prevent fire or injury from leaks.
- If battery liquid leaks, clean the compartment and insert a new battery. Wash skin thoroughly if liquid contacts it.
- Do not disassemble, repair, or modify the remote, as it may cause damage.
- Do not store or carry the remote with small metal objects, which can cause fire or injury from battery rupture.
- Use only manufacturer-recommended batteries.
Unplugging
- Unplug before maintenance, inspection, or moving.
- The appliance has a polarized plug (one blade wider). Insert only one way into a polarized outlet. If it doesn't fit, reverse it. If still no fit, contact an electrician. Do not defeat this feature.
- Grasp the plug to remove; do not pull the cord.
Power Plug and Cord Use
- Failing to use correctly can cause fire or electric shock.
- Insert the plug fully into the socket.
- Regularly remove dust from the plug to prevent fire or shock caused by moisture.
- Use only 120V AC.
- Do not use if the cord or plug is damaged or loose.
- Do not operate with a damaged cord or plug; discard or return for repair.
Power Cord Damage
- Do not damage, modify, bend, pull, twist, pinch, or place heavy objects on the cord.
- Do not use if the cord is bundled; always extend it fully.
- Do not pull the cord when carrying or storing.
Abnormalities and Malfunctions
Stop use immediately, cut power, and unplug if smoke, fire, or electric shock occurs.
Examples of Abnormalities:
- Abnormal sounds or odors.
- Hot power plug or cord.
- Loss of power when cord is moved.
- Product periodically stops.
- Tingling sensation from electric current.
Stop use and contact IRIS USA, Inc. customer service at 1-800-320-4747.
Placement
Place the product on a level floor or table free of obstructions.
- Avoid direct sunlight or hot air from air conditioning/heating appliances, which can cause deformation or malfunction.
- Do not place near radios or TVs, as it may cause interference.
Placement Scenarios
Use with Air Conditioner: Place in front of an air conditioner to circulate cold air, improving cooling.
Use with a Heater: Direct airflow to a corner where a heater is located to circulate warm air and warm feet.
Circulation: Direct airflow towards the ceiling to reduce temperature variations.
Ventilation: Place by a window or door to draw in outside air and expel room air.
Two-room Circulation: Place in an open doorway to circulate air between rooms.
Drying Laundry: Hang laundry directly in the airflow path to speed drying. Avoid placing under dripping clothes.
Parts
Front View
Diagram shows the front of the fan. Key components include: Vane, Front guard, Control panel, Base.
Back View
Diagram shows the back of the fan. Key components include: Handle, Rear guard, Motor, Power plug, Power cord.
Control Panel
Diagram illustrates the control panel buttons and indicator lights:
- Air flow strength indicator lights (showing levels Low, Turbo, High).
- Timer indicator light.
- Timer button.
- Air flow strength button (left/right arrows).
- Breeze setting indicator light.
- Oscillation indicator light.
- Oscillation button.
- Breeze setting button.
- Power button.
Remote Control
Diagram shows the remote control. Key components include:
- Power button: Turns the product on/off.
- Air flow strength buttons (arrows): Select desired airflow.
- Breeze setting button: Activates/deactivates natural breeze mode.
- Timer button: Sets desired run time or clears timer.
- Oscillation buttons (Horizontal/Vertical): Activate/deactivate oscillation.
To use the remote, point the infrared sensor at the receiver on the front of the main body.
Changing Out The Battery
Replace the CR2025 battery when the product is slow to respond.
- Pull out the battery holder by pressing the claw and pulling.
- Insert a new CR2025 battery, ensuring correct polarity (+ side up).
- Reinsert the battery holder.
CAUTION: Improper battery handling can lead to rupture, leaks, and damage. Read 'Remote Use' safety precautions.
Usage Instructions
Place the Product
Place upright on a stable surface and insert the power plug into the outlet. The product beeps when buttons are pressed.
Start the Product
Press the power button to turn the product on. It will start with the last used setting if the plug was not removed. The remote control can also be used.
Select Air Flow Strength
Press the air flow strength button. Use the right arrow button to increase and the left arrow button to decrease airflow.
Levels: Low, Turbo, High.
Start Timer
Press the timer button to set the time: 1 hour, 2 hours, 4 hours, or Timer Off. The remote can also be used.
Stop the Product
Press the power button during operation to turn the product off.
Select Natural Breeze Pattern
Press the breeze setting button to activate the natural breeze pattern (airflow indicator light turns off). Press again to return to normal operation. This can also be controlled via the remote.
Select Oscillation
Use the oscillation button to change the angle. Forcing the angle can damage the product.
- Horizontal: Press button once for left/right oscillation.
- Vertical: Press button while horizontal oscillation is active to switch to up/down oscillation.
- Full Oscillation: Press button while vertical oscillation is active to activate simultaneous left, right, up, and down movement.
- Stop Oscillation: Press button during full oscillation to return to normal operation.
Full Oscillation provides maximum air coverage. Horizontal oscillation is continuous. Vertical oscillation pauses every 20 seconds.
Cleaning and Maintenance
Caution: Always turn off and unplug the product before cleaning. The motor may be hot.
Do not use paint thinner, alcohol, benzene, alkaline detergent, bleach, etc., as they can cause damage or malfunction.
Dusty environments can cause malfunction; clean regularly.
Internal Cleaning
- Unscrew the back cover.
- Press and disengage the 4 claws on the front guard to remove it.
- Remove debris with a vacuum cleaner or a soft cloth.
- Align the front guard claws with the guides, align the handle with the groove, and press until it snaps into place.
External Cleaning
- Wipe lightly with a soft cloth.
- For stubborn dirt, use a cloth with diluted neutral detergent, then wipe with a damp cloth.
Troubleshooting
Before making repairs, consult this table:
Status | Possible Cause | Remedy |
---|---|---|
No power (Indicator is off) | Power plug not securely plugged in. | Plug in securely. |
Low battery power (remote). | Insert a new battery. | |
Incorrect battery polarity. | Ensure correct polarity. | |
Product operation cannot be controlled by remote | Obstruction between infrared sensor and receiver. | Ensure clear path. |
Remote not pointed correctly. | Point remote sensor at receiver (max 16.4 ft / 5.0 m). | |
Product makes loud noise while operating | Product placed on uneven surface. | Place on a level, stable surface. |
Front guard not securely attached. | Attach front guard properly. | |
Low air flow strength | Dust has accumulated. | Clean to remove dust. |
Product makes loud noise while oscillating | Motor sounds increase during oscillation. | This is normal. |
Problems not resolved: Contact your dealer or IRIS USA, Inc. Customer Service.
Warning: Do not disassemble, repair, or modify the product yourself. Service must be performed by an authorized representative.
Product Used Over Long Periods of Time
If any of the following occur after extended use, turn off, unplug, and contact IRIS USA, Inc. customer service at 1-800-320-4747:
- No response when power switch is pressed.
- Strange noise when operating.
- Irregular vane speed changes.
- Bent or damaged power cord.
- Power turns on/off when touching the cord.
- Burnt smell.
Caution: Various factors can degrade the product. If abnormalities occur even with normal use, stop use immediately and contact IRIS USA, Inc. customer service.
Specifications
Model | Specifications |
---|---|
Rated Voltage | 120VAC |
Rated Current | 0.5A |
Rated Frequency | 60Hz |
Product Size (Not Including Power Cord) | 8.27 x 8.27 x 11.42 in / 210 x 210 x 290 mm |
Product Weight | 4.41 lbs / 2.0 kg |
Applicable Area Coverage | 353.4 ft² / 32.83 m² |
Power Cord Length | About 70.9 in / 1.8 m |
*Specifications are subject to change without prior notice.
Manufacturer 1-Year Warranty
The Manufacturer Warrants
IRIS USA, Inc. products are free from defects in material and workmanship under normal non-commercial, household use, when operated and cared for according to the written instructions.
The 1-Year Warranty Does Not Cover
Damage from accident, misuse, abuse, use in humid areas, improper cleaning, neglect, alteration, fire, theft, non-recommended temperatures, minor imperfections, scratches, stains, discoloration, or surface markings that do not impair utility or functionality.
To Obtain Service
Contact IRIS USA, Inc. Customer Service at 1-800-320-4747. Return the product securely packaged with proof of purchase, name, address, phone number, and model number. You are responsible for shipping costs and for any services/parts not covered by warranty.
Manufacturer's Obligation
Manufacturer's liability is limited to repair or replacement at their sole discretion. They will replace defective items with the most comparable current item. IRIS USA, Inc. does not accept special requests or upgrades. They are not liable for special, incidental, or consequential damages. Warranties are exclusive.
Some states may not allow limitations on incidental/consequential damages.
Discontinued Item Returned
If an item is discontinued, IRIS USA, Inc. will replace it with the most comparable current item.
Address:
Attn: Customer Service (Returns Department)
IRIS USA, Inc.
13423 West Cactus Road
Surprise, AZ 85379
©2019 IRIS USA, Inc. All rights reserved.