WOOZOO® Circulator Fan

Introduction

Thank you for your purchase. Please read this instruction manual carefully to ensure proper use. Read all safety precautions prior to use. Please store this instruction manual in a safe place for future reference.

READ AND SAVE THESE INSTRUCTIONS

Safety Precautions

Prior to use, please read the safety precautions carefully to ensure proper use. The precautions listed here are described under classification of Warnings and Cautions, and are intended to prevent harm or damages to users and other persons. All of these precautions are critical in terms of safety. Please follow them at all times.

Graphic Symbol Indications: Indicates content that could lead to death or injury if handled incorrectly.

• ⚠️ CAUTION
• ? PROHIBITED
• ℹ️ INSTRUCTIONS THAT MUST BE FOLLOWED

Disassembly Prohibited

• Do not disassemble, repair, or modify. Doing so can cause fire, electric shock, or injury.
• Repair by persons other than trained repair technicians can be dangerous.
• Warning: To reduce the risk of fire or electric shock, do not use this product with any solid-state speed control device.

Product Use

• Use on a level, stable surface. Placing product on uneven and unstable surfaces can cause the product to fall over, leading to injury or damage to property in the vicinity of the product.
• Place the product in locations where it will not get entangled in curtains or hoisting strings, etc. Failing to do so can cause damage to articles near the product.
• Always grasp the power plug to unplug it, do not unplug it by pulling on the power cord. Pulling on the power cord can damage it, which can cause fire or electric shock.
• Always unplug the power plug from the electric socket when the product will be unused for extended periods of time. Failing to do so can lead to fire or electric shock caused by short-circuits due to reduced insulation.
• This product employs overload protection (fuse). A blown fuse indicates an overload or a short-circuit. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short-circuit occurred and the product should be discarded or returned to IRIS USA, Inc. for inspection and/or repair.

Unplug

• Unplug the power plug from the electric socket when performing maintenance, inspecting, or moving the product.
• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
• Grasp the plug and remove from the receptacle or other outlet device. Do not unplug by pulling on the cord.

Use Power Plugs and Power Cords Correctly

• Failing to do so can cause fire or electric shock due to short-circuits.
• Insert the power plug securely all the way into the electric socket.
• Regularly remove dust from the power plug. When dust is allowed to build up, insulation is hampered due to moisture, which can cause fire or electric shock.
• Use only 120V AC. Other current/voltage can cause fires.
• Do not use if the power cord or the power plug is damaged, or if the power plug is loose when plugged into the electric socket. Doing so can cause fire or electric shock due to short-circuit.
• Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not run the cord under furniture or appliances. Arrange the cord away from high traffic areas and where it will not be tripped over.
• Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair.

Do Not Damage the Power Cord

• Damaging, modifying, forcefully bending, pulling, twisting, putting heavy objects, or pinching can damage the power cord, which can cause fire or electric shock.

Fire Hazards

• Do not use if the power cord is bundled up. Doing so can cause fires. Always extend the cord out before using.
• Do not pull on the power cord when carrying or storing the product. Pulling on the power cord can cause fire or electric shock.

Abnormalities and Malfunctions

Abnormalities and malfunctions can cause smoke, fire, or electric shock.

Stop use immediately, cut power, and unplug from the electric socket when abnormalities or malfunctions occur.

Examples of Abnormalities

• Abnormal sounds or odors.
• Power plug or power cord become abnormally hot.
• Loss of power, etc. when power cord is moved.
• The product periodically stops during operation.
• Tingling sensation from electric current felt when the product is touched.

Stop use and contact IRIS USA, Inc. customer service at 1-800-320-4747.

Avoid Fire Hazards

• Do not spray with insecticides, hair sprays, or lubrication oils, etc.
• Do not use near flammable substances (kerosene, gasoline, paint thinner, etc.), objects that have flames (cigarettes, incense, etc.) or combustible materials. Can cause fires.
• Do not use the product with air flow pointed at a combustible appliance such as a heater. Doing so can cause incomplete combustion or scatter flames, which can cause carbon monoxide poisoning and fire.

Wet Hands Prohibited

• Do not unplug power plug when hands are wet.

General Usage Restrictions

• Do not use the product outdoors.
• Do not use in the vicinity of objects that obstruct the flow of air.
• Do not operate while covered or blocked with cloth, paper, or plastic bags, etc.
• Do not use in locations where there is a lot of dirt or dust. This can cause short-circuit or fire.
• Do not use in rooms with high humidity levels such as bathrooms.
• Do not get the unit wet, or put the unit in water. Getting the product wet can cause fire or electric shock.

If Handled Incorrectly

If handled incorrectly, contents can lead to personal injury or physical damage.

• Keep out of reach of children and infants.
• Do not climb on or tip the product over. Doing so may lead to injury or electric shock.
• Do not drag the product when moving it. Dragging product can damage carpet and floors.
• Do not point air flow directly at your body. It generates a very strong air flow.
• Be especially mindful not to allow children or elderly people near product. Being near the product can be harmful to their physical condition and to their health.
• Air blowing directly on plants may be harmful.
• Do not operate without attaching the vane or the cover. Doing so can cause injury, electric shock, or fire.
• Do not strike the unit forcefully. Doing so can cause the product to malfunction, leading to fire or electric shock.

User Servicing Instructions

• If the fuse on your fan has blown, grasp the plug and remove it from the outlet. Do not pull the cord to unplug.
• To open, slide the fuse cover towards the prongs of the plug.
• Carefully remove the old fuse and snap the replacement fuse into place. To reduce the risk of fire, only replace the fuse with another fuse of the proper rating (2.5Amp, 125Volt). Slide the fuse door back into place to close. Discard the blown fuse. The plug should now be ready for normal use.
• To reduce the risk of fire, do not replace the attachment plug if it is damaged. Only the fuse should be replaced. Discard the product if the attached plug is damaged.
• If you need further information on how or when to replace the fuse in plug, please contact IRIS USA, Inc. customer service at 1-800-320-4747.

Placement

Place the product on a level floor or table free of any obstructions.

• Place the product in locations where it will not come in contact with direct sunlight, or hot air from air conditioning or heating appliances. Such contact can cause the product to deform, change color, or malfunction.
• Do not place the product near the radio or TV. The product may cause noise on radio and affect the TV signal.

Placement Examples

• Use with Air Conditioner: Placing the product in front of an air conditioner to circulate cold air accumulated below creates air flow and provides better cooling. [Diagram: Fan positioned in front of an air conditioner unit, with arrows indicating the circulation of cool air.]
• Use with a Heater: Sending air flow to a corner of the room where the heat source is, to circulate warm air accumulated above, warms feet. [Diagram: Fan positioned to direct airflow towards a corner where a heater might be, with arrows showing warm air circulation.]
• Circulation: Sending air flow toward the ceiling reduces room air temperature variations. [Diagram: Fan positioned to direct airflow upwards towards the ceiling to equalize room temperature.]
• Ventilation: Placing the product by a window or a door draws outside air in and sends in-room air out. [Diagram: Fan placed near a window or door, illustrating drawing in outside air and expelling room air.]
• Two-room Circulation: Placing the product in an open doorway circulates air between two rooms. [Diagram: Fan placed in an open doorway between two rooms, showing air circulation between them.]
• Drying Laundry: Hanging laundry directly in the path of the air flow helps it dry quicker. Do not place underneath dripping clothes as water droplets on the product may cause electric shock or short-circuiting. [Diagram: Fan blowing air onto hanging laundry.]

Parts

Front View

• Vane
• Handle
• Front guard
• Control panel
• Main body
• Base

Back View

• Rear guard
• Motor
• Power plug
• Power cord

Control Panel

The control panel features a knob for adjusting air flow strength and an OFF setting.

• AIR FLOW: Turning the knob to the left or right selects the desired air strength (Low, Medium, High).
• OFF: Stops the product operation.

*Demonstrated model is PCF-HD15NU

Usage Instructions

How to Use

1. Place the Product: Place the product upright on a stable surface and insert the power plug into the electrical outlet.
2. Select the Preferred Air Flow Strength: Turning the knob selects the desired air flow strength (Low → Medium → High). [Diagram: Control knob with settings Low, Medium, High.]
3. Stop the Product: Turn the knob to OFF to stop the operation. [Diagram: Control knob set to OFF.]

Adjusting Angle

• Vertical: The vertical angle can be adjusted manually across 6 steps from approximately -20 to 90 degrees. [Diagram: Fan head tilted at various angles.]

Storage

If the product is not in use for extended periods of time, cover the product and store in places with low humidity and no direct sunlight.

Cleaning and Maintenance

CAUTION: Always turn off the power and unplug the power plug from the electric socket when cleaning the product. Use caution, the motor will be hot immediately after use. Confirm the motor has cooled before cleaning the product.

Do not use paint thinner, alcohol, benzene, alkaline detergent, or bleach, etc. when cleaning the product. Using such substances can cause damage, malfunctions, or changes in color, shape, and quality.

Using the product in dusty conditions can cause it to malfunction. Check and clean the product regularly.

Internal Cleaning

1. Unscrew the screws from the back cover of the fan.
2. Press in and disengage the 4 claws on the top and bottom of the front guard, and then remove the front guard by pulling it toward you. [Diagram: Showing claws on the front guard and how to release them.]
3. Remove debris using a vacuum cleaner. Wipe off debris that cannot be removed by vacuuming using a soft cloth. [Diagram: Vacuum cleaner nozzle cleaning the fan interior.]
4. Align claws on the top and bottom of the front guard with the guides on the back of the guard, align the handle on the back with the groove on the top of the front guard, and press until it snaps into place. [Diagram: Showing how to reattach the front guard.]

External Cleaning

• Wipe lightly using a soft cloth.
• For hard-to-remove dirt, wipe using a cloth containing a diluted neutral detergent.

Troubleshooting

Before making repairs, please read the following content carefully to fix common problems.

Problems that could not be resolved: Please contact the dealer of purchase or IRIS USA, Inc. Customer Service.

Warning: Do not disassemble, repair or modify the product yourself. Any other servicing should be performed by any authorized service representative.

Product Used Over Long Periods of Time

If any of the following problems occur due to use over long periods of time, cut power immediately, unplug from the electric socket, and contact IRIS USA, Inc. customer service at 1-800-320-4747.

• There is no response when power switch is pressed.
• Product makes a strange noise when operating.
• While turning, the vane changes speed irregularly.
• Power cord is bent or damaged.
• Power turns on and off when power cord is touched.
• Product gives off a burnt smell.

WARNING: Various factors can have an impact on the product degradation and malfunction. If abnormalities like those listed above occur even when the product has not been used for the displayed standard period of use, stop use immediately and contact IRIS USA, Inc. customer service at 1-800-320-4747.

Specifications

*Specifications are subject to change without prior notice.

Manufacturer 1-Year Warranty

The Manufacturer Warrants

Your IRIS USA, Inc. products are to be free from defects in material and workmanship under normal non-commercial, household use, when operated and cared for in accordance with the Manufacturer's written instructions provided.

The 1-Year Warranty ("Warranty") Does Not Cover

Any damage caused by accident, misuse, or abuse, including without limitation, damage caused by use in a humid area, improper cleaning, neglect, alteration, fire, theft, non-recommended temperature use and does not apply to minor imperfections, scratches, stains, discoloration, surface markings as a result of shipping or other damage to external or internal surfaces which does not impair the utility and/or functionality of the product.

To Obtain Service

If service should be necessary, you should contact IRIS USA, Inc. Customer Service ("Customer Service") at 1-800-320-4747. You may then return the properly packaged product(s), (using adequate packing and shipping material to prevent damage in transit), with postage prepaid along with name, address, telephone number, model number, and proof of date of purchase (a copy of the receipt) and a detailed description of the claimed defect. This warranty shall not cover any damage incurred to the products during transit to Customer Service. You shall have the obligation and responsibility to: pay for all services and parts not covered by the warranty.

Manufacturer's Obligation

The Warranty may not be altered, expanded, extended, revised or varied except by written instrument executed by the Manufacturer.

THE MANUFACTURER'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT(S) AT THE MANUFACTURER'S SOLE AND EXCLUSIVE OPTION. THE MANUFACTURER WILL REPLACE ANY ITEM FOUND TO BE DEFECTIVE IN MATERIAL OR WORKMANSHIP WITH THE MOST COMPARABLE CURRENT ITEM. IRIS USA, INC. DOES NOT ACCEPT SPECIAL REQUESTS, NOR DO WE HAVE THE ABILITY TO UPGRADE IN EXCHANGE FOR MONEY. THE MANUFACTURER SHALL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES, WHETHER DIRECT OR INDIRECT. THE WARRANTIES SET FORTH HEREIN ARE EXCLUSIVE AND NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR USE ARE MADE WITH RESPECT TO THE PRODUCTS.

Some states do not allow the exclusion of limitation of incidental or consequential damages, so the above limitation exclusions may not apply. This Warranty gives specific legal rights, and there may also be other rights which vary from state to state.

Discontinued Item Returned

If the item returned is discontinued and is no longer available, IRIS USA, Inc. will automatically replace your item with the most comparable item currently manufactured.

Attn: Customer Service (Returns Department)
IRIS USA, Inc.
13423 West Cactus Road
Surprise, AZ 85379

©2019 IRIS USA, Inc. All rights reserved.