Cudy WR1200 Quick Installation Guide

Getting Started

This guide provides instructions for setting up your Cudy WR1200 wireless router.

Note: If your internet source is an Ethernet cable directly from the wall (instead of a modem), connect this cable to the router’s WAN port and skip steps 1, 2, and 3.

Hardware Setup

1. Step 1: Prepare the Modem

   Turn off your modem. If it has a battery, remove it.

2. Step 2: Connect Router to Modem

   Connect the router’s WAN port to your DSL/Cable Modem or Ethernet source using an Ethernet cable.

3. Step 3: Power On Modem

   Turn on the modem and wait approximately 2 minutes for it to restart.

4. Step 4: Connect Router Power

   Connect the power adapter to the router.

5. Step 5: Verify Hardware Connection

   Check the router's LEDs (Power, WiFi, Internet, WAN, LAN1-LAN4) to ensure the hardware is connected correctly.

Computer Connection & Setup

1. Step 6: Connect Your Computer

   You can connect your computer to the router in two ways:

   • Wired: Turn off Wi-Fi on your computer and connect it to one of the router’s LAN ports using an Ethernet cable.
   • Wireless: Connect your device to the router’s Wi-Fi network using the SSID (network name) and Password printed on the bottom of the router.

2. Step 7: Access Setup Interface

   Launch a web browser and enter either http://cudy.net/ or http://192.168.10.1/ in the address bar.

   Log in using 'admin' as the password.

3. Step 8: Configure Internet Connection

   The setup wizard will appear. Follow the on-screen instructions step-by-step to configure your internet connection. This typically involves setting the Operation Mode, Timezone, WAN settings, and Wireless settings.

   Once the setup is complete, you can enjoy internet access.

Router Features

RST/WPS Button

• Press and hold for 1 second to enable the WPS function.
• Press and hold for approximately 6 seconds to reset the router to its factory default settings.

More Features

The Cudy router supports various functionalities. You can access the router's web management page at http://cudy.net/ to configure these features. For detailed instructions, please refer to the user guide available at http://www.cudy.com.

Support & Resources

For technical support, user guides, and additional information, please visit:

• Website: http://www.cudy.com/support
• Email: support@cudy.com

Compliance and Notices

EU Declaration of Conformity

Cudy declares that this device complies with the essential requirements and other relevant provisions of EU directives 2014/53/EU, 2009/125/EC, and 2011/65/EU. The original EU declaration of conformity can be found at http://www.cudy.com/ce.

FCC Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WEEE Directive

In accordance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE - 2012/19/EU), this product should not be disposed of as normal household waste. Please return it to the place of purchase or a designated public collection point for recyclable waste to prevent potential negative consequences for the environment and human health.

GNU General Public License (GPL) Notice

The software code in this product is licensed under the GNU General Public License (GPL). Cudy makes the corresponding GPL source code available upon request via its official website or at https://www.cudy.com/gplcodecenterdownload. The GPL code is supplied without any warranty.