Redmi A2 Quick Start Guide

Getting Started

Press and hold the power button to turn on the device. Follow the on-screen instructions to configure your device.

For more information, visit our official website: www.mi.com/global/service/userguide

About SIM

Do not insert non-standard SIM cards into the SIM card slot, as this may damage the SIM card slot.

WARNING: Do not disassemble this device.

WEEE

This product must be disposed of properly to prevent environmental pollution and health risks. This marking indicates that the device should not be disposed of with regular household waste in EU member states. To ensure sustainable use of material resources, please recycle your waste responsibly. Contact the retailer where you purchased the device for recycling information.

Important Safety Information

Read the following safety information before using the device:

• Using unapproved cables, power adapters, or batteries may cause fires, explosions, electric shocks, or other hazards, or damage the device.
• The operating temperature range for this device is 0°C to 40°C. Using the device in environments with higher or lower temperatures may damage the device.
• If the device has an integrated battery, do not attempt to replace the battery yourself, as this may damage the battery or the device.
• Charge this device only with the included or an approved cable and power adapter, and use only approved accessories compatible with your device.
• After the device is fully charged, disconnect the adapter from the device and the power outlet. Do not charge the device for more than 12 hours.
• The battery must be recycled or disposed of separately from household waste. Improper handling of the battery may cause fire or explosion.
• Dispose of or recycle the device, batteries, and accessories according to local regulations.
• Do not disassemble, strike, crush, or burn the battery. If the battery appears deformed or damaged, stop using it immediately.
• Do not short-circuit the battery, as this may cause overheating, burns, and other injuries or damage.
• Do not expose the battery to high temperatures. Overheating may cause an explosion.
• Do not disassemble, strike, or crush the battery, as this may cause leaks, overheating, or an explosion.
• Do not burn the battery, as this may cause fire or an explosion.
• The user must not remove or tamper with the battery. Battery removal and repair should only be performed by an authorized repair center.
• Keep your device dry.
• Do not attempt to repair the device yourself. If any part of the device does not function properly, contact Xiaomi customer support or take the device to an authorized repair center.
• Connect other devices according to their user manuals. Do not connect incompatible devices to this device.
• For AC/DC adapters, the power outlet must be installed near the device and be easily accessible.

Safety Precautions

• Observe all applicable laws and regulations that restrict the use of mobile phones in certain situations and areas.
• Do not use the phone at gas stations, in explosive atmospheres, or in potentially explosive environments, such as refueling areas, below deck on ships, in chemical and petrochemical storage and transport facilities, and in areas where the air contains chemicals or particles such as flour, dust, or metal powder.
• Observe signs that instruct you to turn off wireless devices such as your mobile phone or other radio devices. Turn off your mobile phone or wireless device when in blasting areas or in areas where you are instructed to turn off "two-way radios" or "electronic devices" to prevent potential hazards.
• Do not use the phone in operating rooms, emergency rooms, or intensive care units of hospitals. Always comply with the applicable regulations in hospitals and health centers. If you rely on a medical device, consult your doctor and the device manufacturer to determine if your mobile phone may interfere with the operation of the device. To avoid potential interference with a pacemaker, the mobile phone should always be kept at least 15 cm away from the pacemaker. This can be ensured by holding the phone to the ear opposite the pacemaker and not carrying the phone in your breast pocket. Do not use the phone near cochlear implants or similar devices.
• Observe aircraft safety regulations and turn off your mobile phone on the aircraft if required.
• When driving a vehicle, use the phone only in accordance with applicable traffic laws and regulations.
• To avoid lightning strikes, do not use the mobile phone outdoors during a thunderstorm.
• Do not use the phone to make calls while it is charging.
• Do not use the phone in environments with high humidity, such as bathrooms. This could lead to electric shock, injury, fire, and damage to the charger.

Safety Notice

Please update your mobile phone's operating system using the built-in software update feature or visit one of our authorized service centers. Updating the software through other methods may cause device damage, data loss, security issues, and other hazards.

EU Regulations

RED Conformity Declaration

Xiaomi Communications Co., Ltd. hereby declares that this digital GSM/GPRS/EDGE/UMTS/LTE mobile phone with Bluetooth and WLAN 23028RN4DG complies with the essential requirements and other relevant provisions of Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.mi.com/en/certification

Information on RF Exposure (SAR)

This device meets the government's requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy. The standards for RF energy emission from wireless devices are based on a unit of measurement called the Specific Absorption Rate (SAR). The SAR limit set by the U.S. Federal Communications Commission (FCC) for this device is 1.6 W/kg. For body-worn operation, this device has been tested and meets FCC RF exposure guidelines when used with an accessory that contains no metal and is positioned at least 1.5 cm from the body. Compliance with FCC RF exposure guidelines for body-worn accessories containing metal has not been tested and certified. Therefore, such accessories should be avoided when worn on the body. When the device is worn on the body using an accessory, the accessory must maintain a minimum distance of 1.5 cm between the body and the device.

Certification Information (Highest SAR Value)

SAR limit 10 g: 2.0 W/kg

SAR value: Head: 0.897 W/kg, Body: 0.997 W/kg (5 mm distance).

Legal Notice

This device can be operated in all EU member states. Please observe national and local regulations when using the device. The usability of this device may be restricted by the network provider. WLAN connectivity (including WLAN frequency bands, WLAN standards, and other functions according to IEEE standard 802.11 specifications) may vary based on regional availability and local network support. The function may be added via OTA as needed.

Restrictions in the 2.4 GHz band:

Norway: This subsection does not apply to the geographical area within a radius of 20 km from the center of Ny-Ålesund.

Please ensure that the network adapters used comply with applicable country regulations and international and regional safety standards.

Frequency Bands and Field Strengths

This mobile phone offers the following frequency bands and maximum radio frequency power only in EU regions:

• GSM 900: 35.5 dBm
• GSM 1800: 32.5 dBm
• WCDMA Band 1/8: 25.7 dBm
• LTE Band 1/3/7/8/20/28/38/40/41: 25.7 dBm
• Bluetooth: 20 dBm
• WLAN 2.4 GHz Band: 20 dBm

FCC Regulations

This mobile phone complies with Part 15 of the U.S. Federal Communications Commission (FCC) Rules. Operation is subject to the following two conditions: (1) this device does not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Information on RF Exposure (SAR)

This device complies with governmental requirements for exposure to radio waves. This device was designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy. The standards for RF energy emission from wireless devices are based on a unit of measurement called the Specific Absorption Rate (SAR). The SAR limit set by the U.S. Federal Communications Commission (FCC) for this device is 1.6 W/kg. For body-worn operation, this device has been tested and meets FCC RF exposure guidelines when used with an accessory that contains no metal and is positioned at least 1.5 cm from the body. Compliance with FCC RF exposure guidelines for body-worn accessories containing metal has not been tested and certified. Therefore, such accessories should be avoided when worn on the body. When the device is worn on the body using an accessory, the accessory must maintain a minimum distance of 1.5 cm between the body and the device.

FCC Notice

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Shielded cables must be used with this equipment to ensure compliance with FCC Class B limits.

E-Label

This device features an electronic label for certification information. To access it, go to Settings > About phone > Certification or open Settings and type "Certification" in the search bar.

Model: 2302RN4DG

2302 indicates that the product will be launched after February 2023.

Model: MDY-09-EW / MDY-14-EQ

For more adapter information, please visit our official website: www.mi.com/global/service/userguide

Disclaimer

This quick start guide is published by Xiaomi or a local affiliated company. Improvements and changes to this guide due to typographical errors, inaccuracies in the information provided, or improvements to programs and/or devices may be made by Xiaomi at any time and without notice. Such changes will be incorporated into new online editions of this quick start guide (for more details, see: www.mi.com/global/service/userguide). All illustrations are for illustrative purposes only and may not represent the exact appearance of the actual device.