Fortinet Rack Mount Tray

Device Compatibility

The Essentials

Admin Guide
For getting started guides, setup and configuration information, refer to the Admin Guides on https://docs.fortinet.com/

Customer Service
For contracts, licensing, product registration and account management, contact FortiCare Support at https://www.fortinet.com/support/contact

Self-service Resources
Access our knowledge base, forums, videos and technical experts at https://www.fortinet.com/support/support-services/forticare-support

Thank you for choosing Fortinet.

Package Contents

• Fortinet Rack Mount Tray (SP-RACKTRAY-02)
• QuickStart Guide
• Fortinet Rack Mount Tray (main component)
• 2x Adapter Brackets
• 8x Cable Ties
• 2x Grounding Wires
• 20x Various Philips M3/M4 Screws
• 4x Hex Screws
• 8x Rubber Feet
• 4x Shoulder Screws

Installation

Before you begin, power off and disconnect the device. If rubber feet are attached, remove them.

Plastic Housing Devices

1. Attach three rubber feet next to the screw holes.
   (Diagram shows rubber feet being attached to the underside of a device)
2. Secure device to the rack tray using two 8mm M3 flathead screws.
   (Diagram shows a device being placed on the tray and secured with screws from underneath)

Tray Mount

1. Place device to one side of the tray above the tray magnets.
   (Diagram shows a device being positioned on the tray)
2. Attach provided grounding wire to the back of the device.
   (Diagram shows a grounding wire being connected)

Optional: Secure device by using the provided 6mm M3 flathead screws or 3.5 M2.5 D4 shoulder slotted screws.

Adapter Bracket Installation

Before you begin, power off and disconnect the device. If applicable, remove the four 4mm M3 screws from the sides of the device. Note, the adapter bracket will not fit devices wider than 216mm (8.5in).

1. Insert two hex screws into the bracket.
   (Diagram shows screws being inserted into an adapter bracket)
2. Place the device onto the adapter bracket, which uses magnets to secure the device.
   (Diagram shows a device being placed onto the bracket, aligning with magnets)
3. Place device to one side of the tray above the tray magnets.
   (Diagram shows the bracketed device being positioned on the rack tray)
4. Attach provided grounding wire from the back of the device to the rack mount using a 6mm M3 panhead screw.
   (Diagram shows a grounding wire connected to the device and the rack mount)

Optional: If applicable, secure the device sides to the bracket using four 6mm M3 flathead screws or use up to two screws to secure the bottom.

Note: The Kensington security slot on the device is not available when the device is installed in the adapter bracket.

Rack Installation

Rack tray dimensions (height x width x length): 1.73in x 18.9in x 14in (44mm x 480mm x 357mm).

1. Level and line up the rack mount tray ear holes with the rack holes.
   (Diagram shows the tray being aligned with rack rails)
2. Finger tighten four rack screws from the rack tray to the rack.
   (Diagram shows screws being loosely attached)
3. Verify that the device is level and there is 1.5 inches of space above and below the device.
4. Tighten the rack screws using a screwdriver.
   (Diagram shows screws being fully tightened)
5. Connect the power and network connections, then secure the power adapter device using the provided cable ties.
   (Diagram shows cables connected and secured)

Caution: To avoid personal injury or damage to the device, we recommend that two people mount the rack tray on a rack.