Fortinet Rack Mount Tray

The Essentials

Admin Guide

For getting started guides, setup and configuration information, refer to the Admin Guides on https://docs.fortinet.com/

Customer Service

For contracts, licensing, product registration and account management, contact FortiCare Support at https://www.fortinet.com/support/contact

Self-service Resources

Access our knowledge base, forums, videos and technical experts at https://www.fortinet.com/support/support-services/forticare-support

Thank you for choosing Fortinet

Package Contents

Fortinet Rack Mount Tray

SP-RACKTRAY-02

• QuickStart Guide
• Fortinet Rack Mount Tray
• 2x Adapter Brackets
• 8x Cable Ties
• 2x Grounding Wires
• 20x Various Philips M3/M4 Screws
• 4x Hex Screws
• 8x Rubber Feet
• 4x Shoulder Screws

Device Compatibility

Installation

Before you begin, power off and disconnect the device; if rubber feet are attached, remove them.

Adapter Bracket

Before you begin, power off and disconnect the device. If applicable, remove the four 4mm M3 screws from the sides of the device. Note, the adapter bracket will not fit devices wider than 216mm (8.5in).

1. Insert two hex screws into the bracket (FG-60D Series).
2. Place the device onto the adapter bracket which uses magnets to secure the device.
3. Place device to one side of the tray above the tray magnets.

Illustration showing hex screws being inserted into the adapter bracket, and then a device being placed onto the bracket.

Optional: Secure the device bottom with 6mm M3 flathead screws.

Optional: If applicable, secure the device sides to the bracket using four 6mm M3 flathead screws or use up to two screws to secure the bottom.

Note: The Kensington security slot on the device is not available when the device is installed in the adapter bracket.

4 Attach provided grounding wire from the back of the device to the rack mount using a 6mm M3 panhead screw.

Rack Installation

1. Level and line up the rack mount tray ear holes with the rack holes.
2. Finger tighten four rack screws from the rack tray to the rack.
3. Verify that the device is level and there is 1.5 inches of space above and below the device for adequate air flow.
4. Tighten the rack screws using a screwdriver.
5. Connect the power and network connections, then secure the power adapter device using the provided cable ties.

Illustration showing the rack mount tray being aligned with rack holes and secured with screws.

Caution: To avoid personal injury or damage to the device, we recommend that two people mount the rack tray on a rack.