Infrared Laser Battle Tank SC6 User Manual

Remote Control - How to use

The remote control unit features two analog joysticks for movement. The left joystick controls forward and backward movement. The right joystick controls left and right movement.

A speaker is indicated. A 'Programming Mode' button allows short presses to switch music and long presses (3 seconds) to turn the spray function on/off. 'Vol-' and 'Vol+' buttons control the volume. An 'Automatic Demo' button initiates an automatic demonstration sequence. A central button cluster includes a button for 'Launch laser' (short press) and 'Restore life' (long press for 3 seconds).

Directional arrows illustrate various movement capabilities: Left Forward, Right Forward, Forward & Left, Forward & Right, Slide Left, Slide Right, Spin Left, Spin Right, Backward & Left.

Infrared Battle

When the remote control car is hit by infrared light, it emits smoke, and its energy level decreases by one step, with a total of seven levels. The energy status is indicated by a light below the turret. When energy is depleted, the light turns red, rendering the tank uncontrollable. To reactivate, either power cycle the tank or press and hold the shooting button for a duration to restore its energy.

Spray Function

To activate the spray function, open the water injection port located at the rear of the car. Use the provided water injection device to fill the tank with clean water. The tank will automatically spray when the spray button is pressed or when it is hit by another remote control car. The process involves injecting water into the rear port and the tank emitting a mist spray.

Battery Installation

SC6 Battery Installation

To install the battery in the SC6 tank, use a screwdriver to remove the battery cover. Connect the 14500/500mAh 3.7V battery to the designated connector. Subsequently, replace the battery cover and secure it with screws. A cautionary note advises to unclasp the connector before pulling it off when removing the battery for charging.

Remote Battery Installation

For the remote control, use a screwdriver to remove its battery cover. Insert two 1.5V AA batteries, ensuring correct polarity alignment as indicated on the unit. Finally, replace the battery cover and screw it back into place.

Battery Warnings

• There is a risk of using lithium batteries, which may cause damage to people and property. The end user must use it carefully and bear all related responsibilities.
• If the battery leaks, avoid contact with skin and eyes. If contact with skin occurs, wash with soap and water immediately. If contact with eyes occurs, rinse immediately with cold water for at least 15 minutes, and seek medical attention.
• If the charger emits a suspicious odor, noise, or smoke, unplug the power supply immediately.

Battery Charging

• The charging light turns on when charging and turns off when it is fully charged.
• Use only the original factory cable. Do not use damaged or cables from other brands.
• Do not charge expanded, leaked, or damaged batteries.
• Do not overcharge the battery. When the battery is fully charged, unplug the device.
• Do not charge near inflammable materials (e.g., carpets, wood flooring, solid wood furniture, etc.).
• Do not charge the battery immediately after it has become hot.
• The charging temperature of the battery should be between 0-40°C (32-104°F).
• Recommend using a 5V 1A charger (Not included) for charging.

Recycling

This equipment consists of electronic components or batteries. For electronic waste, please dispose of according to local waste disposal laws and ordinances.

Charging Time

A new battery needs to be fully charged for 120 minutes and provides up to 25 minutes of use time.

Contact Information

E-Mail: support@contixo.com

Website: www.contixo.com

©2021 Contixo Inc. All rights reserved. Contixo®, the Contixo logo and associated characters, trademarks and design elements are owned and licensed by Contixo Company.