FEVER OR FINE IN A FLASH
High temps are no joke. Is your munchkin just a bit flushed or is this a full-blown fever fest? You need answers RIGHT. NOW. And we're here in the trenches with you. That's where our 3-in-1 True Temp Thermometer comes in, with rectal, oral and armpit reading functions. It gives you both a 10-second quick read and a 30-second final read with a single insertion.
Taking a temp rectally is the only way to go with babies up to one year and is recommended by the AAP as the best method until age three. Middle of the night fever fears? No problem. The built-in LED light lets you see where you're going and what you're doing. (Important for rectal readings...) Worried about going too deep? The insertion stopper's got you covered. Can't remember what your little one's temp was an hour ago? Memory Mode to the rescue!
We've thought of it all so that you don't have to.
Manufacturer & Contact
Manufactured for: Fridababy LLC, Miami, FL 33137
Love it? Leave a review at fridababy.com
Thermometer questions? Contact: fussbuster@fridababy.com
Warnings
- Read instructions thoroughly before using digital thermometer.
- Choking Hazard: Thermometer battery door and battery may be fatal if swallowed. Do not allow children to use this device without parental supervision.
- Do not use thermometer in ear. Designed use is for rectal, oral and armpit (axillary) readings only.
- Do not place thermometer battery near extreme heat as it may explode.
- Remove battery from the device for long-term storage.
- The use of temperature readings for self-diagnosis is dangerous. Consult your doctor for the interpretation of results.
- Do not attempt measurements when the thermometer is wet as inaccurate readings may result.
- Do not bite the thermometer.
- Do not attempt to disassemble or repair the thermometer.
- After each use, disinfect the thermometer.
- Do not force the thermometer into the rectum.
- Do not use thermometer orally after being used rectally, without proper sanitation.
- For children who are two years old or younger, do not use the device orally.
Important Instructions
- This product is not intended to diagnose or treat any health problem or disease and should not be used as a substitute for the consultation and advice of a physician or other medical professional.
- Thermometers should only be used under the supervision of an adult.
- Before use, it is recommended that the patient avoid eating, drinking, smoking or exercising for at least twenty minutes prior to taking a measurement. Never walk, run or talk during a measurement.
Standards Conformance
- ASTM E1112
- IEC 60601-1-2 (EMC)
- ISO 80601-2-56 - Part 2-56
- AAMI/ANSI ES60601-1 (Safety Standards)
- IEC 60601-1-11 - Part 1-11
- ISO 13485 Certified Manufacturing Facility
Contents
- 1 Thermometer
- 1 3V Battery (CR2032)
- 1 Storage Case
- 1 Owner's Manual
- 1 Quick Start Guide
Product Illustration
The thermometer features a flexible tip for comfort and safety. It includes an insertion stopper to prevent over-insertion, especially important for rectal use. A digital screen displays temperature readings in Fahrenheit (°F) or Celsius (°C). A built-in LED light aids visibility during use, particularly in low light conditions. The device has a Power Button to turn it on/off and a Probe Button, likely used for mode changes or specific functions. It is designed with one end specifically for rectal use and the other end for oral or underarm use. The thermometer is described as BPA-free, latex-free, and water-resistant.
EMC Information
Portable and mobile RF communications can affect the device. The device needs special precautions regarding EMC according to the EMC information provided in the accompanying documents.
Specifications
| Specification | Details |
|---|---|
| Type | Digital Thermometer |
| Measure Range | 89.6°F - 111.0°F (32.0°C - 43.9°C) (°C/°F chosen by user) |
| Accuracy | ±0.2°F (0.1°C) during 95.9°F ~ 107.6°F (35.5°C ~ 42.0°C) at 64.4°F ~ 82.4°F (18°C ~ 28°C) ambient operating range + 0.4°F (0.2°C) for other measuring and ambient operating range. Procedures for determining the accuracy of the thermometer are available upon request. *Accuracy: +/- .2F in laboratory testing as stated |
| Operating mode | Predictive Mode |
| Display | Liquid crystal display, 3 1/2 digits |
| Memory | For storing the last 10 values |
| Battery | One 3.0 V DC CR2032 battery |
| Battery life | Approx 200 hours |
| Dimension | 160mm (open) x 32mm x 26mm. (LxWxD) |
| Weight | Approx. 1.35oz including battery |
| Ambient operating range | Temperature: 41°F-104°F (5°C~40°C) Relative humidity: 15% ~ 95%RH |
| Storage and transportation condition | Temperature: -4°F~131°F (-20°C ~ 55°C) Relative humidity: 15% ~ 95%RH |
| Ingress Protection Rating | IP 22 |
| Classification | Type BF |
| Model | 61-067 |
| Gift Box | 92-61003 11/19 |
| Instruction Manual | 93-1471 03/20 |
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; and (2) this device must accept any interference received, including interference that may cause undesirable operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Directions
Temperature Ranges
| Method | Normal Temperature | Fever Range |
|---|---|---|
| Rectal | 97.3°F – 100.4°F | 100.4°F + |
| Oral | 97.0°F – 99.6°F | 99.6°F + |
| Underarm | 95.4°F – 98.6°F | 98.6°F + |
For Rectal Use
The American Academy of Pediatrics (AAP) recommends rectal temperature checks for babies up to one year, and it's the best method until age three. This thermometer defaults to Rectal ("rct") mode.
- Confirm the thermometer is in Rectal ("rct") mode. (See "Change Mode" section below.)
- Before inserting, lubricate the silver tip with a suggested lubricant like coconut oil or other natural options.
- Press the small bump on the thermometer probe to turn on the LED light for better visibility.
- Gently insert the thermometer tip up to the insertion stopper while lifting the baby's legs.
- Do not insert past the point where resistance is felt (typically from the baby's lower cheeks).
For Oral or Underarm Use
- Confirm the thermometer is in the correct mode: Oral ("orl") or Underarm ("udr"). (See "Change Mode" section below.)
- Press the white probe button on the side and flip the tip into oral/underarm mode.
- For Oral Use (recommended for ages four and up): Place the thermometer tip under the tongue.
- For Underarm Use: Place the thermometer probe with the tip in the armpit and keep the arm firmly pressed against the side.
- Note: To ensure an accurate temperature for underarm readings, always wait for the 30-second final reading, as the 10-second reading may not be reliable due to environmental factors like air temperature.
General Operation
- Press the Power Button to turn the thermometer on.
- The last temperature reading will appear on the LCD screen.
- The selected reading mode ("rct," "orl," "udr") will be displayed.
- "---" and the temperature unit (°F or °C) will show on the top right of the screen. (See "Change Unit" section below.)
- Ensure the mode and unit settings are correct before proceeding.
- Taking Temperature (10 or 30-Second Reading):
- 10-Second Read (Quick Check): Insert the thermometer into the appropriate body part based on the mode setting. The screen will show a loading "wheel" [loading-indicator]. The thermometer will beep and flash a temperature reading after 10 seconds.
- 30-Second Read (Final Temperature Check): Keep the thermometer inserted. The screen will continue to flash for another 20 seconds. Once 30 seconds have passed, the reading is complete. The thermometer will beep and display the final temperature reading.
- Wait at least one minute before attempting a new measurement.
- Press the Power Button to turn the thermometer off. This can be done at any point during a reading.
- Remember to sanitize the thermometer before and after all readings, especially if switching between rectal and oral use.
Change Unit (°F / °C)
To change from Fahrenheit (°F) to Celsius (°C): Turn the thermometer on. When the last temperature reading flashes, hold the button for 3 seconds. Press the button once to scroll to the next unit. Once the preferred unit is displayed, press and hold the button for 3 seconds to confirm selection.
Change Mode (Rectal, Oral, Underarm)
The thermometer defaults to rectal ("rct") mode. To change the mode:
- Turn the thermometer on and wait for the screen to light up.
- Hold the button for 3 seconds when the current mode ("rct," "orl," "udr") flashes.
- Press the button once to scroll to the next mode.
- Once the preferred mode is displayed, wait 3 seconds for the thermometer to register the selected mode, OR press the button for 3 seconds to confirm selection and proceed with the reading.
Available modes: "rct" - Rectal, "orl" - Oral, "udr" - Underarm.
For the most accurate results, always use the thermometer in the mode that corresponds with the method you are using.
Memory Mode
To enter Memory Mode: Press and hold the button for 3 seconds when the device is off. Once in memory mode, press the button once to scroll through the saved readings. Press and hold the button for three seconds to exit memory mode.
When to Call Your Child's Doctor
Call your child's doctor right away if your child has a fever and:
- Is younger than 3 months (12 weeks) and has a temperature of 100.4°F (38.0°C) or higher.
- At any age, the fever rises above 104°F (40°C) repeatedly.
Battery Replacement
- Replace the battery when the battery icon [battery-low-icon] appears in the lower right corner of the LCD display.
- Pull the battery door off to open the battery chamber.
- Discard the battery lawfully according to local regulations. Replace with a new 3.0V DC button type CR2032 battery, or an equivalent.
- Slide the battery chamber back into place and reattach the battery door.
Cleaning and Disinfection
- Wipe the thermometer with a soft, clean cloth.
- For stubborn stains, use a cloth dampened with water or a neutral detergent, then wipe thoroughly. Finish by wiping with a soft dry cloth.
- For disinfection, 75% Ethanol or Isopropyl alcohol can be used.
Precautions to Prevent Damage:
- Do not use benzene, thinner, gasoline, or other strong solvents to clean the thermometer.
- Do not attempt to disinfect the sensing section (tip) of the thermometer by immersing it in alcohol or hot water (water over 122°F / 50°C).
- Do not use ultrasonic washing to clean the thermometer.
Troubleshooting / Error Codes
Performance may be degraded if any of the following occur:
- Operation outside stated temperature and humidity range.
- Storage outside stated temperature and humidity range.
- Mechanical shock.
- Patient temperature is below ambient temperature.
Do not dispose of used batteries in the trash. Consult your local recycling center for the proper way to dispose of batteries in your area. Keep used batteries away from children, pets, and excessive heat.
| Error | Problem/Cause | Solution |
|---|---|---|
| Hi | The measured temperature is above 109.2°F (42.9°C). | Results are above range; wait several minutes and attempt a new measurement. |
| Err | The measured temperature is below 89.6°F (32°C). | Results are below range; wait one minute and attempt a new measurement. |
| (System Error) | The system is not functioning properly. | Attempt new measurement; if error persists, contact Customer Care at fussbuster@fridababy.com. |
| Dead battery | Battery icon is flashing, cannot be measurable. | Check battery and replace with a new battery if necessary. |
Normal Body Temperature / Fever Indicator
Body temperature can vary from 97°F to 100.0°F and still be considered normal. The medically accepted 'normal' body temperature is 98.6°F. Body temperature is commonly lower upon waking than at any other point during an individual's waking hours.
Temperature readings will vary based on the body location point of the reading:
- Oral temperature readings between 97°F (36.1°C) and 100°F (37.7°C) are considered normal.
- A rectal temperature reading is generally 1°F (0.5°C) higher than oral.
- An underarm, or axillary, temperature will be 1°F (0.5°C) lower than oral.
A fever is defined as a body temperature that is elevated above the normal for that person. It is important to determine what is normal for an individual before determining if a fever is present. Tracking an individual's temperature consistently, at the same body site and at the same time every day when the person is well, will help determine their normal temperature.
