Gaming Desk with RGB LEDs
Assembly Instructions
Parts List
- Part 1
- Bolt 8mm (x6)
- Part 2
- Screw 8*20mm (x2)
- Part 3
- Screw 6*20mm (x2)
- Part 4
- Screw pin M4 *40mm (x4)
- Part 5
- Screw pin M4 *16mm (x6)
- Part 6
- Foot pad 40*30 (x4)
- Part 7
- Screw 8*50mm (x6)
Included Tools: Wrench [?], Allen Key [?️].
Assembly Steps
Step 1
Prepare the main support bar (Part 1) and its associated wiring. Two small Allen keys are provided.
Step 2
Attach the two Z-shaped leg assemblies to the underside of the desk top. This step requires six (x6) Bolts (Part 2), two (x2) Screws (Part 3), four (x4) Foot pads (Part 7) attached to the bottom of the legs, and six (x6) Screws (Part 8) to secure the main frame components.
Visual Description: The diagram shows the two leg structures being bolted and screwed into pre-drilled holes on the underside of the desk surface. Foot pads are attached to the bottom of the legs.
Step 3
Secure the desk top to the leg assemblies using four (x4) Screw pins (Part 5).
Visual Description: The diagram shows screws being inserted from the sides of the leg structures into the underside of the desk top.
Step 4
Attach additional support brackets to the underside of the desk top using six (x6) Screw pins (Part 6).
Visual Description: The diagram shows angled brackets being screwed into the underside of the desk top, likely for added stability.
Step 5
Attach two (x2) cable management clips (Part 4) to the desk. These are likely screw-in clips.
Visual Description: The diagram shows two clips being screwed into the underside or edge of the desk.
LED Assembly Steps
- Insert the connector wire of the RGB LED strip through the designated hole in the desk top. This helps manage wires and keeps them hidden.
- Secure the LED strip mounting clips or housing onto the Gaming Desk top.
- Attach the provided wire clips to the underside of the desk and route the LED wire through them for tidy cable management.
- The LED lighting system is now installed and the desk assembly is complete.
Visual Description: The steps show the process of feeding the LED wire through the desk, attaching the LED strip components, and using clips for wire management.
