SIMAGIC TB-1 Quick Guide

1. List of Accessories

1.1 List of Standard Accessories

• ? USB data cable X 1
• ⚙️ Elastomer kit X 1
• ? Button Head Socket Cap Screw M6-14 X 4
• ? Roll in T-Nut with Ball Spring M6-40 X 4
• ? Allen Key (2mm/4mm/6mm) X 3

1.2 List of Optional Accessories

P-LOK:

• ? Multifunctional L-Shaped Bracket X 1
• ? Button Head Socket Cap Screw M6-14 X 4
• ? Countersunk Head Screw M6-14 X 4
• ? Roll in T-Nut with Ball Spring M6-40 X 4
• ? Allen Key (4mm) X 1

2. Installation Method

2.1 Product Assembly

1. Mounting the handbrake.

Note: The L-Shaped mounting plate can be purchased separately.

Diagram: Illustrates the handbrake unit being mounted. Red arrows show M6-14 bolts securing the unit to a surface. A 'Bottom View' diagram displays the four mounting hole positions on the base of the handbrake. The text indicates that M6 bolts, with a maximum length of 20mm, should be used for mounting.

2. Product connection ports.

Diagram: Shows the rear of the handbrake unit, clearly indicating the location of the USB Type-C socket for connection.

2.2 Elastomer Swap

1. Remove the front plate. Diagram: Shows the front plate of the handbrake being removed, with two M3-14 bolts indicated for removal.
2. Remove the bolt.

   Note: Make sure the power is OFF during the replacement.

   Diagram: Depicts a bolt being removed from the handbrake mechanism.
3. Swap the elastomer. Diagram: Illustrates the process of removing the existing washer and elastomer, followed by installing a new elastomer. Text indicates that this step is performed to adjust the resistance of the Handbrake.

2.3 Handle Adjustment

2.3.1 Adjust the lever.

Diagram: Shows the handbrake lever. A red arrow points to a screw mechanism, with accompanying text stating "Fine-tune the angle of the handle."

2.3.2 Switching lever position

1. Remove the lever. Diagram: Shows the handbrake lever detached, with M6-14 bolts indicated for removal.
2. Flip the lever. Diagram: Illustrates the lever being flipped and re-inserted. Text instructs to remove the M6-14 bolts, flip the position of the handle, then re-insert the bolts and tighten.

Software & Applications

Install SimPro Manager on PC to complete setup.

Product Tutorial: Available via the SIMAGIC website or by scanning QR codes found on product packaging.

Note: SimPro Manager is required to complete the setup of the TB-1 Handbrake.