KitchenAid Appliance Handle and Knob Installation
Personalize your hardware.
Installing Your New Range Handle
Tools required: Allen wrench (included with kit)
- Loosen the set screws on the underside of the handle using the included tool.
- Pull the handle away from the door and save the set screws.
- Place the new handle onto the studs with the screw holes facing downward.
- Slide the handle onto the studs until it is flush with the door.
- Hold the handle firmly against the door.
- Tighten the screws until secure.
- Do not over-tighten the screws.
Help protect the metal by removing jewelry from hands, using a soft cloth when handling tools & parts, and removing the protective film after installation is complete.
Installing Your New Range Knobs and Bezel
- Pull the knob away from the unit, removing it from the stem.
- Remove the screw holding the bezel in place.
- Turn the bezel counterclockwise and pull it away.
- Secure the new bezel by turning it clockwise.
- Fasten the bezel in place.
- Replace the knob by aligning the crescent shape of the stem.
- Push firmly until seated.
- Repeat for all knobs and bezels.
Installing Your New Refrigerator Handle
Tools required: Set screw
- Loosen the two set screws on the inside of the handle using the included tool.
- Pull the handle away from the door and save the set screws.
- Place the new handle onto the studs with the screw holes facing inward.
- Slide the handle onto the studs until it is flush with the door.
- Hold the handle firmly against the door.
- Tighten until secure.
- Do not over-tighten screws.
- Repeat for other handles.
Installing Your New Wall Oven Handle
Tools required: Set screw
- Loosen both set screws using the included tool.
- Pull the handle away from the door and save the set screws.
- Place the new handle onto the studs with the screw holes facing downward.
- Slide the handle onto the studs until it is flush with the door.
- Hold the handle firmly against the door.
- Tighten until secure.
- Do not over-tighten screws.
Installing Your New Wall Oven Knobs
- Pull the knob away from the unit.
- Replace the knob by aligning the crescent shape of the stem.
- Push firmly until seated.