KitchenAid: Designed to be Personalized

General Information

Before you start: Help protect the metal by removing jewelry from hands, using a soft cloth when handling tools & parts, and removing the protective film after the installation is complete.

Tools you will need: Allen wrench (Included with kit)

Note: Instructions are also provided for all dishwasher and under counter appliances.

Range Hardware Installation

Installing Your New Range Handle

Figure 1: Shows the set screw and Allen wrench.

Figure 2: Illustrates the handle attachment process.

• Loosen the set screws on the underside of the handle using the included tool.
• Pull the handle away from the door and save the set screws.
• Place the new handle onto the studs with screw holes facing downward.
• Slide the handle onto the studs until flush with the door.
• Hold the handle firmly against the door.
• Tighten the set screws until the handle is secure.
• Do not over-tighten screws.

Visuals can vary on commercial range.

Installing Your New Range Knobs and Bezel

Figure 1: Shows the knob being pulled away from the unit.

Figure 2: Illustrates removing the bezel screw and turning the bezel.

Figure 3: Depicts replacing the knob by aligning the stem.

• Pull the knob away from the unit, removing it from the stem.
• Remove the screw holding the bezel in place.
• Turn the bezel counterclockwise and pull it away.
• Secure the new bezel by turning it clockwise.
• Fasten the bezel in place.
• Replace the knob by aligning the crescent shape of the stem.
• Push firmly until seated.
• Repeat for all knobs & bezels.

Refrigerator Hardware Installation

Installing Your New Refrigerator Handle

Figure 1: Shows the set screw and Allen wrench.

Figure 2: Illustrates the handle attachment process to the refrigerator door.

• Loosen the set screws on the inside of the handle using the included tool.
• Pull the handle away from the door and save the set screws.
• Place the new handle onto the studs with the screw holes facing inward.
• Slide the handle onto the studs until flush with the door.
• Hold the handle firmly against the door.
• Tighten the set screws until the handle is secure.
• Do not over-tighten screws.
• Repeat for other handles.

Wall Oven and Cooktop Hardware Installation

Installing Your New Wall Oven Handle

Figure 1: Shows the set screw and Allen wrench.

Figure 2: Depicts the handle attachment process to the wall oven door.

• Pull the handle away from the door and save the set screws.
• Place the new handle onto the studs with screw holes facing downward.
• Slide the handle onto the studs until flush with the door.
• Hold the handle firmly against the door.
• Tighten the set screws until the handle is secure.
• Do not over-tighten screws.

Installing Your New Wall Oven or Gas Cooktop Knobs

Figure 1: Shows the knob being pulled away from the unit.

• Pull the knob away from the unit.
• Replace the knob by aligning the crescent shape of the stem.
• Push firmly until seated.
• Repeat for all knobs.