C2C34 INSTALL GUIDE
DIMENSIONAL RENDERINGS
Diagram 1: Grill Top/Front View (Closed Lid)
A 3D rendering of the Coyote C2C34 grill from a slightly elevated front-left angle, showing the main grill body with the lid closed and side shelves extended. Key dimensions indicated: Width 36 1/8 inches, Depth 25 1/2 inches, Height 23 inches.
Diagram 2: Grill Top/Front View (Open Lid)
A 3D rendering of the Coyote C2C34 grill from a slightly elevated front-right angle, with the lid open, revealing the cooking grates and interior. Key dimensions indicated: Height 31 inches (with lid open), Depth 20 1/2 inches (with lid open).
Diagram 3: Base Unit/Island Cutout View (Front)
A rendering of the grill's base or cabinet structure, viewed from the front. Key dimensions indicated: Width 36 1/8 inches, Depth 23 inches, Height 11 inches. This represents the base unit or island cutout requirement.
Diagram 4: Island Cutout Dimensions (Front)
A rendering of the grill's base or cabinet structure, viewed from the front, showing the cutout dimensions for an island installation. Key dimensions indicated: Width 34 1/4 inches, Depth 22 1/8 inches, Height 10 1/4 inches.
| Model No. | Height | Width | Depth |
|---|---|---|---|
| C2C34 | 23" | 34" | 25 1/2" |
| CJAKTCC3 | 11" | 36 1/8" | 23" |
| Model No. | Height | Width | Depth |
|---|---|---|---|
| C2C34 | 10 1/4" | 31" | 20 1/2" |
| CJAKTCC3 | 11" | 34 1/4" | 22 1/8" |
When using a Coyote insulated jacket, build your island to the jacket's Cutout and Overall Dimensions listed above. Once the jacket is installed, the grill will rest on/inside the insulated jacket.
| Model No. | Gas Supply | BTU'S | Regulator | WC Pressure | Max PSI | Electrical Requirements |
|---|---|---|---|---|---|---|
| C2C34LP | Propane | 60,000 | 20 lb Tank Regulator | 11" | .5 PSI | Qty 1 - 120 VAC 60 Hz Grounded Plug |
| C2C34NG | Natural Gas | 60,000 | 1/2" Female Pipe | 4" | .5 PSI | Qty 1 - 120 VAC 60 Hz Grounded Plug |
Important Note to Installer: This file is not intended to replace your Owner's Manual, which contains specific safety requirements and consumer guidelines. Please refer to your Owner's Manual prior to installing or operating your built-in grill.
COYOTE Outdoor Living
Visit: www.coyoteoutdoor.com
CONSTRUCTION REQUIREMENTS
NON-COMBUSTIBLE CONSTRUCTION
Insulated Jacket NOT Required
Diagram 5: Non-Combustible Construction - Top View
Shows the grill opening in an island for non-combustible construction. Key dimensions: Grill Opening Width 31 inches, Grill Opening Depth 20 1/2 inches, Grill Overhang 1 1/2 inches. A gas connection point is indicated.
Diagram 6: Non-Combustible Construction - Front View
Shows the grill installed in an island from the front for non-combustible construction. Key dimensions: Opening Height 11 inches, Opening Width 34 1/4 inches. Minimum clearances: 2 inches to Doors/Drawers, 1 1/2 inches to Countertop.
- Combustible material cannot be within 24 inches of the grill's frame (horizontal & vertical).
- The shaded area on the "TOP VIEW" illustrates the 24" minimum requirement (not to scale).
- The grill is designed to hang from the countertop with no support underneath.
- Minimum rear clearance for the hood to open is 2 inches.
- If a wall/partition is behind the grill, the minimum rear clearance should be at least 7 inches for ventilation of the exhaust.
COMBUSTIBLE CONSTRUCTION
Insulated Jacket Required - Model # CJAKTCC3
Diagram 7: Combustible Construction - Top View
Shows the grill opening in an island for combustible construction, requiring an insulated jacket (Model # CJAKTCC3). Key dimensions: Liner Opening Width 31 inches, Liner Opening Depth 22 1/8 inches, Jacket Overhang 7/8 inches. A gas connection point is indicated.
Diagram 8: Combustible Construction - Front View
Shows the grill installed in an island with an insulated jacket from the front for combustible construction. Key dimensions: Opening Height 11 inches, Opening Width 34 1/4 inches. Minimum clearances: 2 inches to Doors/Drawers, 1 1/2 inches to Countertop.
- If using combustible material within 24 inches of the grill frame, you MUST use the corresponding Coyote Insulated Jacket.
- Using an insulated jacket does not waive any other standard installation procedure (ventilation, connections, etc.).
- The jacket is designed to hang from the countertop with no support underneath.
- Minimum clearance for hood to open is 2 inches.
- If a wall/partition is behind the grill, the minimum rear clearance to that wall should be at least 7 inches to allow for ventilation of the exhaust.
Ventilation Requirements:
- Regardless of building material, include at least two vents within the island.
- Vents must be at least 20 sq. in. each and allow fresh air movement from the grill cabinet to the exterior.
- For propane setups, install vents lower, as propane is heavier than air.
- For natural gas setups, locate vents higher, as natural gas is lighter than air.
- Do not locate the two vents on the same wall; cross-ventilation is key for dissipating excess heat or trapped gas.
Important Note to Installer: This file is not intended to replace your Owner's Manual, which contains specific safety requirements and consumer guidelines. Please refer to your Owner's Manual prior to installing or operating your built-in grill.
COYOTE Outdoor Living
Visit: www.coyoteoutdoor.com
