PLATSA Furniture Assembly Instructions
Important Safety Information
WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.
Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.
Parts Included
- 8x Screw (Part #151705)
- 8x Screw (Part #151706)
- 4x Screw/Bolt (Part #108736)
- 4x Cam Lock Part (Part #152059)
- 4x Cam Lock (Part #146113)
- 2x Cap/Cover (Part #10005905)
- 2x Cap/Cover (Part #126916)
- 2x Foot/Leg (Part #150689)
- 2x Bracket/Connector (Part #150688)
- 2x Wall Bracket (Part #10090922)
Assembly Steps
Step 1
Assemble the main frame panels. Two people are recommended for this step.
Diagram shows two people connecting two large rectangular panels. Close-up views illustrate inserting screws and turning cam locks to join the panels.
Step 2
Fold up the side panels of the partially assembled frame.
Diagram shows a person folding up the side panels of the frame.
Step 3
Attach another panel to the frame and secure it using cam locks.
Diagram shows a person attaching a panel and inserting cam locks. A close-up shows a cam lock being turned with a screwdriver.
Step 4
Attach the top panel to the frame and secure it using cam locks.
Diagram shows a person attaching the top panel. Close-up views show cam locks being inserted and turned.
Step 5
Secure the assembled frame using eight screws (Part #151705).
Diagram shows the assembled frame with arrows indicating where to insert eight screws.
Step 6
Attach the support brackets (Part #150688) to the top edge of the unit.
Diagram shows the unit from the back. Brackets are being attached to the top edge. A wall attachment component (Part #10090922) is also shown being connected.
Step 7
Place the unit upright on its feet (Part #150689).
Diagram shows the unit standing on its feet.
Step 8
Attach components to the top of the unit.
Diagram shows a unit from the side. A component is being attached to the top edge.
Step 9
Connect multiple units together and adjust for stacking.
Diagram shows two units being connected side-by-side. Arrows indicate vertical adjustment for stacking.
Step 10
Attach wall mounting brackets (Part #126916) to the unit using screws (Part #10005905). Ensure they click into place.
Diagram shows the unit from the side. Wall brackets are attached to the top edge with screws. A close-up shows the bracket being secured with a "CLICK!" sound indicated.
Step 11
Connect two units side-by-side using connector brackets (Part #10090922) and screws (Part #146113).
Diagram shows two units being joined. Connector brackets are attached and secured with screws.
Step 12
Attach the wall bracket (Part #10090922) to the unit and then secure it to the wall using screws (Part #146113). Use the numbered scale for precise alignment.
Diagram shows the wall bracket being attached to the unit and then to the wall. A numbered scale is visible on the bracket for accurate placement.
Step 13
Secure the joined units to the wall using the provided wall attachment hardware.
Diagram shows two units joined side-by-side, with wall brackets being attached to the wall.
Step 14
Stack units vertically, ensuring a maximum height of 300 cm (118 7/64"). Connect units using screws (Part #108736) and cam lock parts (Part #152059).
Diagram shows two units being stacked. Arrows indicate the connection points. A maximum height is indicated. Close-up views show screws and cam lock parts being used for connection.
