Welcome to the Kwikset family!
This guide will get you ready to install your handleset.
If you have any issues, please visit our support center: kwikset.com/support or call us at 1-800-327-5625.
Installation and Reference Guide
This manual can be used to install a variety of handlesets.
Recommended Tools
Recommended tools include a Phillips screwdriver, a flathead screwdriver, a hammer, a wood block, and a measuring tape. Note: Specific tools may depend on the installation type.
For assistance with door preparation, please refer to specific instructions. For assistance with drilling instructions, please refer to specific instructions.
Screw Reference
Interior Trim
Screw A: Interior trim mounting screw.
Handleset
Screw B: Handleset mounting screw.
Screw C: Handleset mounting screw.
Component D: Washer.
Component E: Part of the handleset mechanism.
1 Install Handleset
A. Install Handleset
Attach the exterior part of the handleset to the door. The post is adjustable and can be moved to any position within the slot for proper alignment.
B. Secure Handleset
Attach the bottom of the handleset using the provided washer and screw. Once secured, snap the cover into place.
2 Install Interior Trim and Lever
A. Install Interior Trim
Install the interior trim plate. Secure it to the door using the top mounting screws (A x2).
B. Secure Lower Trim
Align the interior trim plate and secure it with the lower mounting screws (B x2). Ensure the plate is kept parallel to the door edge.
C. Install Lever
Insert the interior lever into its mounting position.
D. Tighten Set Screw
Tighten the pre-installed set screw. Fully tighten the set screw using the long end of the Allen wrench.