Artemide Tizio LED

Safety Warnings

• Before any operation on the fixture, disconnect the power supply.
• The fixture cannot be supplied by an outlet provided with a dimmer.
• Ensure the transformer is equipped with the proper outlet adapter.
• Before connecting the transformer to the outlet, verify that the rated voltage marked on it matches the available network voltage.
• No type of connection between fixtures and transformers/outlets different from those defined by ARTEMIDE is allowed.

Diagram Description: The illustration shows the base of the Artemide Tizio LED lamp, featuring a control button labeled 'A', alongside various plug adapters for different electrical outlets.

Operation

The fixture is equipped with a dimmer for light intensity regulation.

• To turn on: Briefly touch push button A located on the base.
• To regulate intensity: Keep push button A pressed. Release at the desired level or maximum level.
• To reverse dimming direction: A second long press of push button A will reverse the direction of light intensity regulation, dimming towards the minimum.
• To turn off: Briefly touch push button A.

When turning the fixture on again, it will recall the same light intensity that was set before it was turned off.

LED Replacement

The fixture is fitted with a light source characterized by an extremely long lifespan.

Should the LED require replacement, this operation must be performed exclusively by specialized Artemide personnel.

Please contact your nearest Artemide dealer for assistance. For addresses of Artemide dealers worldwide, visit the official website: www.artemide.com.

Compliance and Safety

All ARTEMIDE products falling within the scope of the European Low Voltage Directive (2006/95/CE) and the European Electromagnetic Compatibility Directive (EMC 2004/108/CE) meet the required specifications and bear the 'CE' marking.

Fixtures in Class II must be powered by a safety transformer compliant with current regulations.

The fixture has been tested according to the standard IEC 62471:2006 for photobiological safety of lamps and is classified in the exempt risk group.

Artemide s.p.a. assumes no responsibility for products modified without prior authorization.

In case the power supply cable needs replacement, please contact the ARTEMIDE service center.

The electrical safety of this fixture is guaranteed only when used according to these instructions. Therefore, it is essential to keep them for future reference.