Artemide Tolomeo Micro LED

Important Safety Information

Before any operation on the fixture, disconnect the power supply. The fixture cannot be supplied by an outlet provided with a dimmer.

Mounting Options

Table Base Assembly

Assemble the lamp body (A) into the table base (B). Secure with bush (C), washer (D), and screw (E). Adjust the stiffness of the fixture by turning the ring nuts (F).

Wall Mount Assembly

Attach the support (G) to the wall. Insert the lamp body (A) into its designated seat by rotating and pressing downwards.

Clamp Mount Assembly

Secure the clamp (H) using screw (I). Insert the lamp body (A) into its seat by rotating and pressing downwards.

Fixed Table Mount Assembly

Drill a hole (diameter 18.5-19.5mm) in the desired surface. Insert the support (L) and lock it with the ring nut (M). Insert the lamp body (A) into its seat by rotating and pressing downwards.

Floor Mount Assembly

Insert the stem (N) into the base (O) and secure it with the washer and screw (P). Position the three wire holders (Q) on the stem (N). Insert the lamp body (A) into its seat by rotating and pressing downwards. Route the power cable through the wire holders (Q).

Operation and Dimming

Connect the transformer with the appropriate plug adapter. Ensure the transformer's rated voltage matches the mains supply. The fixture is equipped with a dimmer for light intensity adjustment. To turn the lamp on or off, briefly touch the central part of the switch (R) on the power cable. To adjust brightness, keep the switch (R) pressed. A prolonged press increases intensity to the maximum; a second prolonged press reverses the direction, decreasing intensity. The lamp will resume the last set brightness level upon reactivation.

LED Replacement

The LED light source offers an extremely long lifespan. Should replacement become necessary, it must be performed exclusively by specialized Artemide personnel. Contact your nearest dealer or visit www.artemide.com for addresses.

Compliance and Safety Information

This product complies with EU Low Voltage Directive (2006/95/CE) and EMC Directive (2004/108/CE), bearing the "CE" mark. It is classified as Class III and requires a safety transformer. Photobiological safety testing (IEC 62471:2006) places this lamp in the "exempt" risk group. Artemide s.p.a. is not liable for products modified without prior authorization. For power cable replacement, contact Artemide service. Ensure electrical safety by following these instructions, which should be kept for future reference.