Artemide Tizio Micro Lamp

General Warnings

Attention: Disconnect the mains voltage before any operation on the fixture.

Caution: Only use lamps of the type and wattage indicated on the rating plate. ARTEMIDE spa does not accept any responsibilities should products be modified without prior authorization.

Note: Prior to any work on the fixture, always disconnect the power.

Vorsicht: Vor jedem Eingriff an dem Gerät die Netzspannung unterbrechen.

Achtung: Ausschließlich Leuchtmittel verwenden, die auf dem Geräteschild angegebenen Typ und Wert entsprechen. ARTEMIDE s.p.a. nimmt keine Verantwortung für ohne Vornahme geänderte Produkte an.

Advertencia: Desconectar la tensión de red antes de cualquier operación sobre el aparato.

Atención: Utilizar exclusivamente las bombillas del tipo y potencia indicada en la placa del aparato. ARTEMIDE spa no se asume ninguna responsabilidad ante productos modificados sin autorización.

Bulb Replacement

Instructions:

1. Pull the spring A and remove it from its housing.
2. Remove the glass B and replace the lamp C.
3. Replace the lamp with a similar one (base: G 4 frosted); press-fit it in the socket and make sure that it is properly placed.
4. Do not touch the lamp glass with your bare hands. Should this happen, clean it with some alcohol.
5. Reposition the cover glass B, insert the spring in the proper seat and push gently until it is fixed.
6. ATTENTION: during this operation, check that the chamfer of the cover glass B is positioned on the front side of the head and turned outwards.
7. Press the red switch button to turn it on or adjust the light intensity.

Bulb Specification:

20W 12V HSG G 4 halogen bi-pin frosted. Use low pressure lamps only.

General Information and Safety

The symbol 'F' indicates the suitability of fixtures to be mounted directly on normally inflammable surfaces. Fixtures without this symbol are only suitable for installation on non-inflammable surfaces.

All ARTEMIDE products comply with European directives for electromagnetic compatibility (E.M.C. 89/336 and amendments) and low voltage (B.T. 73/23 and amendment), indicated by the 'CE' marking.

The number enclosed within the symbol indicates the minimum distance in metres to which the objects to be illuminated should be placed. The distance is measured on the axis of vision of the fixture from the fixture side or from the lamp nearer to the illuminated object.

For the replacement of the power supply cable, please contact the ARTEMIDE technical service centre.

Artemide reserves the right to introduce technical and structural modifications for product improvement at any time.

Attention: Electrical safety is guaranteed only when used as indicated in these instructions. Therefore, they should be kept for future reference.

Product Details

Product Code: Y503000637

Manufacturer: Artemide S.p.A.

Address: via Bergamo, 18--20010 Pregnana Milanese (Milano)--ITALIA

Contact: Tel: +39 02 935181, Telefax: +39 02 93590254 / 93590496

Website: http://www.ARTEMIDE.CO

Tax ID/VAT: 00846890150