B600 Automatic Bark Collar User Manual

Important Safety Information

Explanation of Attention Words and Symbols used in this User Manual

WARNING

Not for use with aggressive dogs. Do not use this product if your dog is aggressive, or if your dog is prone to aggressive behavior. Aggressive dogs can cause severe injury and even death to their owner and others. If you are unsure whether this product is appropriate for your dog, please consult your veterinarian or certified trainer. Do not puncture or incinerate the collar or the refill cannister. Do not expose to extreme heat or store at temperatures above 113 °F or 45 °C.

Lithium Rechargeable Batteries: This device contains Lithium-Polymer (Li-Polymer) batteries; never incinerate, puncture, deform, short-circuit, or charge with an inappropriate charger. Fire, explosion, property damage, or bodily harm may occur if this warning is not followed.

Do not expose the device to freezing temperatures (32 °F or 0 °C) or to conditions warmer than 113 °F or 45°C. Do not leave the collar in direct sunlight. Never leave the collar in a car where the device can heat up to high temperatures (113 °F or 45 °C).

CAUTION

This product is not a toy. Keep it away from the reach of children.

Risk of skin damage. Please read and follow the instructions in this manual. Proper fit of the collar is important. A collar worn for too long or made too tight on the pet's neck may cause skin damage, ranging from redness to pressure ulcers; this condition is commonly known as bed sores.

• Avoid leaving the collar on the dog for more than 12 hours per day.
• When possible, reposition the collar on the pet's neck every 1 to 2 hours.
• Check the fit to prevent excessive pressure; follow the instructions in this manual.
• Never connect a leash to the electronic collar.
• When using a separate collar for a leash, don't put pressure on the electronic collar.
• Wash the dog's neck area and the contact area of the collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• If a rash or sore is found, discontinue use of the collar until the skin has healed.
• If the condition persists beyond 48 hours, see your veterinarian.

These steps will help keep your pet safe and comfortable. Millions of pets are comfortable while they wear smooth contacts. Some pets are sensitive to contact pressure. You may find after some time that your pet is very tolerant of the collar. If so, you may relax some of these precautions. It is important to continue daily checks of the contact area. If redness or sores are found, discontinue use until the skin has fully healed.

This Bark Stopper should be used only on healthy dogs. We recommend that you take your dog to a veterinarian before using the collar if he is not in good health.

1. Main Features

• [IC Chip] IC "Power Max"
• 💧 IPX6 waterproof
• [M Button] Double button setting
• [Battery Icon] 500mAh large compacity battery
• [Sound/Vibration Icon] Voice + vibration intelligent dual trigger recognition system
• [No Barking Icon] Unique and accurate anti-trigger control detection
• [Motor Icon] High power motor
• [Level Indicator] The independent dual-mode level setting system

2. Relevant Description

Microphone Sensor

Charging Port (with cover)

[Silicone Sleeve] Conductive Silicone Sleeve

Level Display

Beep+Vibration Mode Indication

Mode selection and level setting

Beep+Vibration+Static Stimulation Mode Indication

Battery Status

Power Button

3. How to Use It

Turn on/Turn off

Turn on: Press the power button one time. The green light will turn on, accompanied by two beeps. Turn off: Press and hold the power button for 1.5 seconds. The device will turn off with one beep. Standby: The device will enter Standby mode after 1 minute of inactivity.

Two different function mode switching

This bark stopper has two different function modes: with static stimulation function and without static stimulation function. You can switch modes by pressing the M button.

• Mode 1 (With static stimulation function): Includes beep, vibration, and static stimulation. The corresponding red stimulation icon is displayed. (See diagram 3B)
• Mode 2 (Without static stimulation function): Includes beep and vibration functions. The corresponding green vibration icon is displayed. (See diagram 3C/3D)

Anti-bark Modes: Cyclic and Fixed

This bark stopper has two different anti-bark modes: cyclic and fixed.

• A: Cyclic Mode (Default): The first triggering is a Level 1 warning. If the dog continues to bark, it progresses to Level 2, up to Level 6 warning.
• B: Fixed Mode: The LCD display shows the current corresponding level. You can adjust the level from 1 to 6 by pressing and holding the M button. Release the button when you reach the desired level.

Cycle and Fixed Mode Switching

Defaults mode is cycle mode.

• To switch to Fixed Mode: Press and hold the M button.
• To switch back to Cycle Mode: Press the power button three times continuously and quickly. The LCD display will show 0.

Note:

• The device has 1-6 different levels. Under both modes, when triggered, it will display and flash the current corresponding level. For example, under Level 6, it will display the number 6 and flash for 3 seconds until the barking stops.
• Under both modes, after the 6th triggering, the device will enter 'Protection Mode', stop working for 1 minute, and flash '0'.

4. Charging

(Please charge before use!)

Charging Instruction

Low battery: The battery indicator shows red and displays one bar (See diagram 4A). The battery indicator will scroll during charging and will become solid green with 4 bars when fully charged (See diagram 4B).

Charging Device

The charging cable is a DC interface with 5V output voltage. (Attention: Please use the original charging cable to charge. If you use others, the output voltage must be 5V, otherwise it may cause charging failure.)

Testing Light Instructions

1. Press the power button to turn on the collar.
2. Hold the Test Light Contacts to the collar's contact points.
3. Set the collar to static stimulation function mode.
4. Make a sound similar to "Wang, Wang" (imitating dog barking) near the sensors. Since the frequency of human voice is different from that of dogs, please test multiple times.

5. Wearing Method

Important note: The correct wearing and positioning of the bark stopper collar is important for effective operation.

To ensure proper wearing, please follow the steps below:

1. Make sure the bark stop collar is closed.
2. Keep your dog in a comfortable standing position. (As shown in diagram A)
3. Place the bark stop collar on the dog's neck, ensuring the control ring is in the center and the "on/off" switch on the operating surface of the collar faces upward. (As shown in diagram B)
4. Check the tightness of the bark stop collar by inserting a finger between the dog's collar and the back of its neck. The proper position should be comfortable rather than tight. (As shown in diagram C)
5. Let your dog wear the collar for a few minutes, then recheck the fit. Properly adjust the collar to make the dog more comfortable using the "bark stopper collar". (As shown in diagram D)
6. Trim the collar as follows:
1. Mark the required collar length with a pen.
2. Remove the bark stop collar from the dog and cut off the excessive length. Use a flame to seal the neckline along the worn edge.
3. Then put the bark stop collar on your dog.

Please read and follow the instructions in this manual. Proper fit of the collar is important. A collar worn for too long or made too tight on the pet's neck may cause skin damage.

• Avoid leaving the collar on the dog for more than 12 hours per day.
• When possible, reposition the collar on the pet's neck every 1 to 2 hours.
• Check the fit to prevent excessive pressure; follow the instructions in this manual.
• When using a separate collar for a lead, don't put pressure on the electronic collar.
• Wash the dog's neck area and the contacts of the collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• Never connect a lead to the electronic collar; it will cause excessive pressure on the contacts.

6. Summary Of Frequently Asked Questions

Q: Why doesn't the bark stopper work when the dog is barking?

A: There are many possible reasons. Users can make some judgments and analysis based on the following:

1. Make sure the product is powered and worn correctly, under the dog's throat.
2. Not all barking will trigger the device; sometimes the dog is barking to welcome the owner. The device distinguishes this via an identification chip. The product is mainly for bad barking or continuous barking.

Q: Can I not use the static stimulation function?

A: Of course, just adjust the mode to "without static stimulation function".

Q: Is the Vibration/Stimulation safe for my pet?

A: Although Vibration/Stimulation is unpleasant, it is harmless to your pet. Electronic training devices require interaction and training from the owner to achieve desired results.

Q: Once my pet has been trained and no longer has bad barking, will he have to continue to wear the collar?

A: Probably not, but you can also turn off the collar and leave it on the dog to strengthen training.

Q: Is the product waterproof?

A: Yes. But please make sure that the rubber cover for charging is placed in the correct position and that dogs are not allowed to swim with it.

Q: How about the after-sales service?

A: If it is a quality problem, not caused by man-made damage or misoperation, we guarantee it for 1 year. We recommend that you start with the "without static stimulation function" mode to let your dog adapt to the beep/vibration function first, to avoid excessive reactions. If your dog shows no reaction to beep/vibration, then start at Level 1 static stimulation. Please note to always start at the lowest level.

7. FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Caution: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

8. Declaration of Conformity

Reference Weight for Dogs

Large Dog (Body height above 24 inch, Weight above 88 lbs)

Medium Dog (Height 16-24 inch, Weight 24.2-66 lbs)

Small Dog (Height 10-16 inch, Weight 8.8-22 lbs)

Mini Dog (Height under 10 inch, Weight under 8.8 lbs)

Reference Size for Different Dogs

About After-Sales

1. If the product is faulty within 30 days from the purchase date, you need to take a video or picture of the faulty product. After the customer service confirms, the replacement can be sent. The faulty product must be returned within 7 days after receiving the replacement.
2. If the product is faulty after 30 days, and it is still within the 1-year warranty period from the purchase date, the consumer will be required to return the product and pay the freight. We will test and replace the faulty parts, and return them to you free of charge.
3. This warranty is a supplement to other rights and remedies provided by law. For major failures and any other compensation, if it is a reasonably foreseeable loss or damage, you are entitled to a replacement or refund.
4. You also have the right to repair or replace the goods in the following cases: the quality of the goods is unqualified, and the failure does not constitute a major failure. If you have any questions or need more information, please contact our customer service.

Service Center and Distribution

The device has been approved for use in EU countries and is therefore provided with the CE mark. All necessary documentation is available on the website: www.electric-collars.com. Changes to technical parameters, properties, and printing errors reserved.

Service center and distribution:

Reedog, sro
Sedmidomky 459/8 101
00 Prague 10

Phone: +1 646 980 4569

Email: info@electric-collars.eu