Yaheetech 610957 10x10 ft Heavy-Duty Pop-Up Canopy Tent Installation Guide

Important Information

Please read this instruction manual carefully before attempting to install.

Model Number: 610957

Assembly Recommendations and Safety Precautions

Assembly Preparation

Please follow the instruction manuals and use a pad to avoid damage during assembly.

Parts Identification

Identify all components before starting assembly:

• ① Canopy Fabric (x1)
• ② Canopy Fabric Storage Bag (x1)
• ③ Frame Storage Bag (x1)
• A Tent Stakes/Pegs (x4)
• B Ropes/Cords (x4)
• C Sand Bags (x4)
• D Carrying Bag (x1)

Step 1: Unpacking Components

Unpack and take out the canopy fabric and the frame storage bag. Other parts are packed in the frame storage bag; please take them out for further assembly.

Note: Please do not use a knife when unpacking to avoid cutting the product and parts accidentally.

[Illustration: Two people carefully unpacking the canopy fabric and frame storage bag from a box.]

Step 2: Erecting the Frame

Erect the frame and half-open it.

[Illustration: A canopy frame being set up and partially opened.]

Step 3: Attaching Canopy Fabric

Place the canopy fabric on the frame and align the four corners of the canopy fabric with the four corners of the frame.

[Illustration: Canopy fabric being draped over the partially opened frame, with corners being aligned.]

Step 4: Securing the Frame

[Illustration: Two people pulling up the horizontal bars of the canopy frame. Close-up views show how the bars connect and lock into place.]

Step 4 Continued: Finalizing Frame Setup

Pull the drawstring on the fabric to fix the top. Attach the canopy fabric to the frame with the hoop and loop fasteners. Extend the canopy frame to the full. Pull up the horizontal bars until you hear a "click" from the four frame corners. The canopy fabrics are now set.

Step 5: Reinforcing Canopy Attachment

After setting up the canopy fabric, reinforce the fabric to the frame with the hook and loop fasteners in the middle of each side.

[Illustration: Canopy fabric attached to the frame, with a close-up showing hook-and-loop fasteners being secured on the sides.]

Step 6: Banner Attachment Points

On the face of the canopy, there are 4 hoops for mounting a banner (banner not included).

[Illustration: The canopy structure with a banner attached to the top hoops. The Yaheetech logo and tagline are visible on the banner.]

Step 7: Adjusting Canopy Height

There is a spring button on each leg for height adjustment.

[Illustration: A person adjusting the height of a canopy leg by pressing a button. A close-up shows the leg mechanism with numbered height adjustment points (1, 2, 3).]

Step 7 Continued: Height Adjustment Procedure

Each leg has 3 holes for 3 adjustable heights. Adjust the canopy height by pushing the spring buttons and sliding the telescopic outer tubes along the legs.

Note: Push the spring button until the outer tube of the leg is movable, then release the button. Extend the telescopic legs to your desired height, and the button will automatically lock in place. Please do not overextend the frame legs, otherwise the canopy fabric may be damaged.

Step 8: Securing with Sand Bags

Fill up the sand bags and tie them to the frame legs.

[Illustration: Sand bags being filled and tied securely to the base of each canopy leg.]

Step 9: Anchoring the Canopy

[Illustration: Ropes connecting the canopy fabric to stakes. Stakes (labeled 'A') are shown being hammered into the ground.]

Step 10: Final Stability Anchoring

Connect the canopy fabric and the ground anchors with ropes, and fix the anchors into the ground for added stability.