LH4000 RFID Hotel Lock
ZKTeco
Key Features
- ? With advanced 13.56MHz Mifare-1 card technology
- ? American standard mortise with 5 latches
- ? Zinc Alloy housing with bright chrome finish (Only outdoor unit)
- ? With professional hotel lock management software - single click install
- ? Audit trail records the latest 224 lock transactions
- ? With warning beeps in low battery power
- ? Backset is 70 mm
Specifications
Feature | Detail |
---|---|
Software | ZKBiolock Hotel Lock System |
Card Type | ISO14443 (RFID) Type-A S70 4KB/S50 1KB |
Operating Temperature | 0 - 45 °C |
Net Weight | 3 kg |
Package Dimension | 410 × 218 × 145 mm |
Door Thickness | 35-55 mm |
Dimensions (mm)
Front View: Height 260 mm, Width 112 mm, Handle Length 70 mm.
Side View: Width 70 mm, Depth 28 mm.
Top/Bottom View: Length 203 mm, Width 28 mm.
Detailed View: Height 110 mm, Width 97 mm, Depth 62.5 mm, Screw Hole Spacing 9 mm.
Compliance and Regulatory Information
EU Declaration of Conformity
ZKTECO CO.,LTD declares that this Product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Operational Warnings and Notes
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure and Installation Guidelines
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.