YTTRAN Kitchen Mixer Tap
Overview
This document provides assembly instructions for the IKEA YTTRAN kitchen mixer tap.
Contents
- Tools and Spare Parts
- Illustration of Product, Parts, and Part Numbers
- Product Assembly
Safety and Compliance
Important: Installation must be carried out in accordance with industry regulations Säker Vatteninstallation.
Safety Instruction: Switch off the main shut-off valve before changing the mixer tap.
This product is an accepted assembly instruction (2021:1) and certified to EN 817 and EN 1717. It is registered under TG 1266 by KIWA (1913). Swedish RSK Number: 8312177 / English RSK Number: 8312177.
Parts and Tools
Required Tools:
- Wrench
- Sealant Gun
Online Resources: Visit www.IKEA.com for more information.
Parts List:
- Part 120087
- Part 120141
- Part 120142
- Part 120172
- Part 110084
- Part 120143
- Part 126908
- Part 123031
- Part 139269
Connection Sizes:
- G3/8 (R10)
- G3/4 (R20)
Operating Specifications:
- Recommended Operating Temperature: Max. 60°C
- Maximum Operating Temperature: Max. 80°C
- Recommended Operating Pressure: 1-5 bar
- Maximum Operating Pressure: 0.5-10 bar
Assembly Steps
Step 1
Illustration: Hand inserting part 120143 into the mixer tap body.
Step 2
Seal the open surfaces around the tap base with silicone sealant to prevent water penetration into the worktop upon any leaks. Silicone sealant is not included.
The silicone sealant must be water- and mould-resistant and suitable for installation, according to EN 15651-3, Class XS1.
Recommended hole diameter for the worktop: 34-37 mm (1 3/8" - 1 1/2").
Warning icon: Ensure silicone sealant meets EN 15651-3, Class XS1 requirements.
Step 3
Connect the cold and hot water pipes. Ensure the pipe connection is flat and free from sharp edges.
IMPORTANT! Do not overtighten: this can damage hoses, pipes, and washers.
Step 4
Observe the mixer tap's swivel range: 120 degrees and 360 degrees.
Reiteration of warnings: Ensure pipe connections are flat and free from sharp edges. Do not overtighten to avoid damaging hoses, pipes, and washers.
Step 5
Warning: Risk of property damage. If the dishwasher connection is not required, it must be capped with a G3/4" (R20) brass plug.
Reiteration of warnings: Ensure pipe connections are flat and free from sharp edges. Do not overtighten to avoid damaging hoses, pipes, and washers.
Final Checks and Usage
Before initial use: Unscrew the aerator/flow guide with a coin. Allow water to run freely for a few minutes. Then screw the aerator/flow guide back into place until it stops. DO NOT OVERTIGHTEN.
Aerator/Flow Guide Status: Closed. Aerator/Flow Guide Status: Open.
Check at regular intervals to ensure that the installation is not leaking.
