INSJÖN Kitchen Mixer Tap with Pull-Out Spout Installation Guide
This guide provides essential instructions for the correct installation and use of the IKEA INSJÖN kitchen mixer tap with a pull-out spout.
General Installation Requirements
Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional.
Preparation
Before commencing installation, switch off the main shut-off valve to stop the water supply.
Installation Steps
The installation involves several steps, referencing various components:
Component Identification:
- Part 1: Mixer tap body
- Part 2: Pull-out spout
- Part 3: Flexible hose
- Part 4: Hose weight
- Part 5: Mounting hardware
- Part 6: Seals/washers
- Part 7: Screws
- Part 8: Handle
- Part 9: Base plate
- Part 10: Water inlet hoses
Assembly Procedure:
- Ensure a suitable hole is prepared in the worktop with a diameter of 34-37 mm (1 3/8 - 1 1/2 inches).
- Connect the pull-out spout (Part 2) to the flexible hose (Part 3).
- Mount the mixer tap body (Part 1) through the worktop hole, potentially using the base plate (Part 9).
- Secure the tap from underneath using the mounting hardware (Part 5) and screws (Part 7).
- Attach the handle (Part 8) to the tap body.
- Connect the water inlet hoses (Part 10) to the main water supply.
- Attach the hose weight (Part 4) to the pull-out hose.
- Seal open surfaces around the tap base with silicone (not included) to prevent water ingress into the worktop in case of leaks.
Technical Specifications and Warnings
- Maximum Operating Temperature: 60°C (140°F)
- Maximum Safe Temperature: 80°C (176°F)
- Recommended Water Pressure: 1-5 bar (0.1-0.5 MPa / 14.5-72.5 psi)
- Maximum Allowed Water Pressure: 0.5-10 bar (0.05-1 MPa / 7.2-145 psi)
- Connection Type: G3/8 (R10)
- IMPORTANT WARNING: Do not tighten too hard, as this can damage hoses/pipes and washers.
- Aerator/Flow Guide: Before initial use, unscrew the Aerator/Flow Guide with a coin. Let water run freely for a few minutes to flush the system. Screw the Aerator/Flow Guide back into place until it stops, but DO NOT OVER TIGHTEN.
Maintenance and Checks
Regularly check the installation to ensure there are no leaks.
