Warranty Information
DO NOT RETURN PRODUCT TO STORE. Contact Baby Trend for replacement parts, service, and repair.
The Baby Trend® warranty covers workmanship defects within the first 180 days of purchase. It is voided by misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration, accident, or if the serial number has been altered or removed.
Damage to property during installation is the end user's sole responsibility.
Customer Service can be contacted at 1 (800) 328-7363, Monday through Friday, between 8:00 AM and 4:30 PM PST.
Return Authorizations are required for product returns. Warranty is valid only in North America.
Parts Included
Verify you have all parts before assembling the stroller:
- Stroller frame
- Canopy for sun protection
- Seat unit
- Child tray for snacks/drinks
- Front wheel (swivel lockable)
- Bumper bar
- Rear wheels
- Soft parent organizer for storage
- Infant car seat attachment points
- Base (for infant car seat, refer to separate manual)
Note: Front and rear wheel types may vary.
Safety Warnings & Precautions
⚠️ General Safety: Please follow all instructions to ensure child safety. Keep instructions for future reference.
⚠️ Serious Injury/Death Hazard: Failure to follow instructions could result in serious injury or death. Avoid falls or sliding out by always using the safety harness and ensuring proper child positioning.
⚠️ Supervision: Never leave children unattended.
⚠️ Tip-Over Hazard: Wheels can detach and cause tip-overs. Pull on wheels to ensure they are securely attached.
⚠️ Finger Entrapment: Be careful when folding and unfolding the stroller to prevent finger entrapment.
Usage Restrictions & Guidelines:
- Only approved Snap Tech™ products can be used on the frame.
- Do not place items like purses, shopping bags, or diaper bags on the stroller, as they can alter balance and create an unstable condition.
- Maximum weight limits: Basket: 5 lbs (2.26 kg); Child tray: 1 lb (0.45 kg); Parent organizer: 3 lbs (1.36 kg). Exceeding these limits can cause instability.
- Ensure the stroller is fully open and locked before allowing a child near it.
- Using the stroller with a total weight over 50 lbs (22.67 kg) can cause excessive wear and stress, leading to instability.
- NEVER use the stroller on stairs or escalators.
- NEVER use the stroller with roller skates, in-line skates, skateboards, or bicycles.
- NEVER allow children to use the stroller as a toy.
❗ Important: For safe operation, follow instructions carefully and keep them for future reference.
❗ Pre-Use Check: Before assembly and each use, inspect for damaged hardware, loose joints, missing parts, or sharp edges. NEVER use if parts are missing or broken.
❗ Assembly: Adult assembly is required.
Assembly Instructions
Remove stroller from box. Front and rear wheels MUST be installed before use.
Front Wheel Installation
1. Unlock the release lever (refer to Figure 1a). Unfold the stroller frame by pulling upward on the handle until it locks (refer to Figure 1b).
2. Lean the stroller backward so the front wheel post points upward. Push the front wheel assembly onto the post until it clicks securely into place (refer to Figure 1c). Note: Pull on the wheel assembly to confirm it is securely attached.
Rear Wheel Installation
3. Lean the stroller forward to rest on the front wheels.
4. Press the rear wheel posts into the rear frame hub until they click into place (refer to Figure 2). Note: Pull on the rear wheel to ensure it is securely attached.
Note: NEVER use the stroller if wheels do not lock into place. For assistance, contact customer service at 1-800-328-7363 (Mon-Fri, 8:00 AM - 4:30 PM PST).
Adjustable Handle
5. To adjust the handle, press the release buttons simultaneously and move the handle up or down to a comfortable position (refer to Figure 3). Note: Ensure the handle clicks into place before use.
Bumper Bar
6. Attach the bumper bar by aligning its anchors with the slots on the seat. Push until it clicks into place (refer to Figure 4a). Note: The bumper bar must be securely attached before use.
7. To detach the bumper bar, press the release button at its base, pull the bar out of the anchor, and swing it upward to access the seat (refer to Figure 4b).
⚠️ Fall Hazard: The bumper bar is not designed to be used as a carry handle or to support a car seat, as this can make the stroller unstable.
⚠️ Child Restraint: The bumper bar is not designed to hold the child. The child must always be secured by the 5-point safety harness.
Attaching the Seat
8. Ensure the seat fabric is properly attached to the seat support bar. If the zipper is open, wrap the fabric around the bar and zip it closed (refer to Figure 5a).
9. Attach the seat by aligning the seat anchors on its side with the anchors on the stroller frame. Push them together until they click securely (refer to Figure 5b). The seat can face forward or backward.
Adjusting the Seat
10. The seat can be adjusted to upright, reclined, and carriage positions. Pull the recline button on the rear of the seat and rotate it to the desired position (refer to Figure 6a).
11. Upright/Reclined Positions: Buckle the footrest straps at the rear of the seat. Pull excess straps to tighten (refer to Figure 6b).
12. To recline the seat further, loosen the head strap through the buckle and adjust to the required position (refer to Figure 6c).
13. To return the seat to a more upright position, press upward on the seat back with one hand while pulling the head strap through the buckle with the other (refer to Figure 6d). The strap will lock automatically. The upright position is for children at least 6 months old. Always readjust the safety harness, including shoulder belts, when repositioning the seatback.
14. Carriage Position: Loosen both footrest and headrest straps and fully extend the seat surround (refer to Figure 6b).
Removable Canopy
15. To attach the canopy: Snap the clips inside the toddler seat tubes (refer to Figure 7a).
16. To open the canopy: Push forward on the front edge while holding the rear edge in place (refer to Figure 7b).
17. To fold the canopy: Pull backward on the front edge (refer to Figure 7b).
Soft Parent Organizer
18. Strap the organizer onto the stroller handle using the hook and loop fasteners (steps 1-3, refer to Figure 8). Ensure it is fastened tightly.
⚠️ Parent Tray Limit: Do not place hot liquids or more than 3 lbs (1.36 kg) in the parent tray. This can cause burns or instability.
Child Tray
19. To attach the child tray: Align the tray with one of its three positions and push down onto the bumper bar until it clicks firmly into place (refer to Figure 9a). Note: Ensure the tray locks into one of the three positions before use.
20. To remove the child tray: Push the tray tab outward and pull upward (refer to Figure 9b).
⚠️ Child Tray Limit: Do not place hot liquids or more than 1 lb (0.45 kg) in the child tray. This can cause burns or instability.
⚠️ Tray Attachment/Removal: Be careful when attaching and removing the child tray to prevent finger entrapment.
Safety Guidelines
Brakes
21. Engaging Brakes: Always set the brakes when the stroller is stopped to prevent it from rolling away. Never leave the stroller unattended on inclines.
22. Apply downward pressure to the brake levers on the rear axle. You may need to move the stroller slightly forward or backward to engage the brake (refer to Figure 10). Note: Verify the stroller does not move once brakes are applied.
23. To release the brakes, gently lift the brake levers.
Front Wheel Lock
24. The front wheels have a swivel locking device. Push the button on each wheel upward to engage the locks and downward to disengage them (refer to Figure 11).
Securing the Child
25. Harness Adjustment: The 5-point harness straps have 3 adjustable positions. Select the position where the shoulder strap is level with or below the top of the child's shoulder (refer to Figure 12a).
26. To adjust harness height, unhook the shoulder strap from the crotch buckle. Feed the strap through the harness slots located on the rear of the seat, under the fabric. Feed through the appropriate slot and reattach to the buckle.
27. Place the child in the stroller seat. Bring the safety harness around the child's waist and over their shoulders. Place the crotch strap between the child's legs. Insert the male ends of the shoulder/waist belts into the crotch strap buckle. Tighten the harness to be snug around the child's waist and over their shoulders (refer to Figure 12b).
28. To release the harness buckles, press the button on the center clasp (refer to Figure 13).
⚠️ Strangulation Hazard: A child can strangle in loose straps. Never leave a child in the seat with loose or undone straps.
Infant Car Seat Attachment
29. Attachment: Attach the car seat facing the stroller handle. Align the seat anchors on the car seat with the stroller frame anchors and push together until they lock securely (refer to Figure 14). Only approved Snap Tech™ products can be used on the frame.
30. Removal: To remove the seat or infant car seat, pull up on both release levers and lift the seat or car seat upward (refer to Figure 15).
⚠️ Car Seat Safety: Avoid serious injury from falls or sliding out; always use the Infant Car Seat harness.
Folding and Unfolding
To Fold the Stroller
31. Pull the stroller backward several inches to bring the front wheels forward.
32. Fold the stroller by pulling both release triggers (refer to Figure 16a) and pushing the handle towards the floor. Ensure front wheels lie flat. Secure the stroller in the folded position by locking the fold latch (located on the right side of the stroller) over the rivet (refer to Figure 16b).
Note: Remove all items from the basket before folding.
❗ Caution: Do not allow children near the stroller while folding.
⚠️ Finger Entrapment Warning: Be careful not to pinch fingers when folding or unfolding.
To Unfold the Stroller
33. Unlock the release lever (refer to Figure 17a). Unfold the stroller frame by pulling upward on the handle until the frame locks (refer to Figure 17b).
❗ Caution: Do not allow children near the stroller while unfolding.
Care and Maintenance
Seat Pad
To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth. Note: DO NOT machine wash.
Other
Regularly check your stroller for loose screws, worn parts, torn material, or stitching. Replace or repair parts as needed.
Discontinue use if the stroller malfunctions or is damaged. Contact customer service for repair or replacement parts.
Riding Positions
The stroller can be used in various riding positions, including upright, reclined, and carriage modes, as detailed in the assembly section.
⚠️ Fall Hazard: The bumper bar is not designed to support a car seat; doing so may make the stroller unstable.
