Dr. Brown's Deluxe Bottle Warmer and Sterilizer
Quick Reference Guide
Before first use, scan to review the Instruction Manual for full warnings and detailed instructions.
Preparing for Use
The device consists of a warming chamber, a removable reservoir, a warming basket, and a lift-out basket. A power cord is included.
- Remove the water reservoir from the rear of the warmer.
- Add water to the reservoir. Replace water after 24 hours or when water is depleted, whichever comes first.
- Place the reservoir back in position. Ensure the warming basket and lift-out basket are correctly placed inside the warming chamber. Uncoil the power cord and plug it into a wall outlet.
Warming
Follow these steps to warm bottles or food jars/pouches.
- Complete steps 1-3 in the 'Preparing for Use' section.
- Place the item to be warmed into the warmer as described below.
- Close the lid securely.
- Press the [Power/Start Cycle Button].
Warming Specifics:
- Bottle: Remove bottle components and attach the storage cap for leak-free warming. Place the bottle into the lift-out basket and then the warming basket.
- Food Jar/Pouch: Loosen the lid of the food jar or pouch. Place it into the lift-out basket, then lower the entire assembly into the warming basket.
Setting Warming Time:
- Press the [Vessel Type Button] repeatedly to select the correct vessel type and material. Options include:
- Narrow Plastic Bottle
- Narrow Glass Bottle
- Wide Plastic Bottle
- Wide Glass Bottle
- Food Jar/Pouch
- Use the [Up Arrow Button] or [Down Arrow Button] to select a preset volume of liquid.
- Press the [Starting Temperature Button] until the desired temperature condition for the vessel appears. Options include:
- Room Temperature
- Refrigerated
- Frozen
- Manual Time Adjustment: While in the 'Starting Temperature Condition' mode, use the [Up Arrow Button] or [Down Arrow Button] to increase or decrease the warming time.
- Press the [Power/Start Cycle Button]. The time setting will flash. Press the [Power/Start Button] again to begin the warming cycle.
- When the cycle is complete, open the lid and allow any remaining steam to clear. The unit will beep every 10 seconds for 1 minute (press the [Power/Start Button] to silence). Promptly remove the vessel to avoid overheating. Gently stir or swirl contents to ensure even warming. Do not shake.
Sterilizing
Follow these steps to sterilize baby items.
- Wash items to be sterilized in hot, soapy water and rinse them thoroughly.
- Complete steps 1-3 in the 'Preparing for Use' section.
- Place items into the sterilizer as described below:
- Bottles: Place the reservoir tube and bottle upside down in the lift-out basket. Lower this into the warming basket. Place any remaining bottle parts inside the lid.
- Small Items: Place items into the lift-out basket, then lower this into the warming basket. Place any remaining small parts inside the lid.
- Close the lid securely.
- Press the [Power/Start Cycle Button].
- Press the [Starting Temperature Button] until the Sterilize icon appears. The appliance will default to a 6:00 minute cycle.
- Press the [Power/Start Cycle Button]. The time setting will flash. Press the [Power/Start Button] again to begin the sterilizing cycle.
- When the cycle is complete, open the lid and allow any remaining steam to clear. The unit will beep every 10 seconds for 1 minute (press the [Power/Start Button] to silence).
