Dr. Brown's Deluxe Bottle Warmer and Sterilizer Quick Reference Guide

Preparing for Use

Before first use, scan to review Instruction Manual for full warnings & detailed instructions.

1. Check that the warmer is unplugged. Remove the reservoir from the rear of the warmer.
2. Add water to the reservoir.
3. Put the reservoir back in place. Ensure warming basket and lift-out basket are in warming chamber. Plug in.

Warming

1. Prepare items for warming:

   • BOTTLE: Remove bottle components and add storage cap.
   • FOOD JAR: Loosen lid of food jar.
2. Close the lid of the warmer.
3. Press the [Power Button].

4. Set warming time:

   • Choose plastic bottle or glass bottle.
   • Choose Glass Bottle for food jar.
   • Choose a preset volume of liquid. If your volume is not an option, select closest preset below your volume and manually increase time in the next step.
   • Choose 5 oz / 150 mL for food jar.
   • Choose starting temperature condition: frozen, refrigerated, or room temperature.
   • Use [Up Arrow] or [Down Arrow] Button to increase or decrease time.
5. Press the [Cycle Start Button].

Sterilizing

1. Prepare items for sterilizing:

   • BOTTLE: Place reservoir tube and bottle upside down in lift-out basket. Lower into warming basket. Put remaining items inside lid.
   • SMALL ITEMS: Place items into lift-out basket, then lower into warming basket. Put remaining items inside lid.
2. Close the lid.
3. Press the [Power Button].
4. Press the [Starting Temperature Condition Button] until the [Sterilize Icon] appears.
5. Press the [Cycle Start Button].

Warming Time Chart

Times are pre-programmed for full bottles. This time chart is approximate. Warming times will vary depending on the vessel material, shape and volume. Tempered glass has been tested for use in this warmer.

*For shortcut to food jar times, use Glass Bottle 5 oz/150 mL preset.