BESTÅ TV Bench Assembly Instructions

Safety Warnings

WARNING: Children have died from furniture tipover. To reduce the risk of furniture tipover:

• ALWAYS install the anti-tip device provided.
• NEVER allow children to stand, climb, or hang on any drawers, doors, or shelves.
• ALWAYS secure your television with an anchor device.

Read and follow each step of the instructions carefully.

Visual Descriptions:

• Correct lifting of panels by two people.
• Incorrect lifting of panels by one person (prohibited).
• Furniture placement on a soft surface (carpet) is correct.
• Furniture placement on a hard surface with a sharp edge is prohibited.
• Person consulting instructions with a question mark.
• Person interacting with furniture and instructions, with an IKEA store symbol.
• TV on a cabinet with a warning triangle symbol.
• TV secured to the wall with an anchor device; unsecured TV is prohibited.

Parts List

Assembly Steps

Step 1

Attach the feet (114947, 115988) to the bottom panels (144342) using screws (130618).

Step 2

Insert cam lock screws (130618) into the pre-drilled holes on the side panels and bottom panels.

Step 3

Connect the side panels to the bottom panels by inserting the cam lock screws into the corresponding holes and then tightening the cam locks (130619, etc.).

Step 4

Attach back panel supports (133209, etc.) and side panel connectors (144351, etc.) using screws (113287, 109049) and dowels (118137, etc.).

Step 5

Attach brackets (115444, 115443) to the side panels using screws (113287, 122971, 141028, 130725, 119253).

Step 6

Insert the vertical dividers into their designated slots.

Step 7

Attach the top panels (133203, etc.) to the assembled structure using cam lock screws (118137, etc.) and cam locks (130619, etc.).

Step 8

Slide the back panels into the grooves.

Step 9

Place the top surface onto the assembled unit, aligning it with the connectors.

Step 10

Secure the top surface by turning the cam locks (130619, etc.) to lock the cam lock screws (130618).

Step 11

Insert shelf supports (144567, etc.) into the desired height positions on the inside of the unit.

Step 12

Place the shelves onto the shelf supports.

Step 13

Attach wall mounting brackets (109049) to the top rear of the unit using screws (133203, etc.) and (144567, etc.).

Step 14

Route cables through the designated openings and clips.

Step 15

Attach cable management clips (133209, etc.) to secure cables.

Step 16

Adjust the feet (114947, 115988) by screwing them in or out to level the unit.

Step 17

Further adjust the feet (114947, 115988) to ensure the unit is stable and level.

Step 18

Attach the anti-tip hardware to the wall and the unit. This involves securing a bracket to the wall and connecting it to the unit using a strap or cable. Ensure the connection is firm.