METOD High Cabinet Assembly Instructions

Important Safety Information

⚠️ WARNING: Furniture tip-over can cause serious or fatal crushing injuries. To prevent tip-over, this furniture MUST be secured to the wall using the provided wall attachment device(s).

Note: Screws and plugs for the wall are not included. Use screws and plugs suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instructions carefully.

This warning is provided in multiple languages.

Assembly Steps

Step 1: Prepare Side Panels

Insert 12x dowels (112996) into the pre-drilled holes on the two side panels.

Step 2: Attach Top Panel

Attach the top panel to the side panels. Insert 12x cam locks (113434) into the corresponding holes on the top panel and turn them to secure the side panels.

Step 3: Attach Back Panel Supports

Insert 6x dowels (101351) into the side panels. Attach the back panel support pieces to the side panels using screws.

Step 4: Attach Bottom Shelf

Attach the bottom shelf to the side panels using 6x cam locks (113434) and 6x dowels (101351).

Step 5: Insert Middle Shelf

Slide the middle shelf into the cabinet frame, resting it on the pre-installed supports or dowels.

Step 6: Attach Top Shelf

Attach the top shelf to the side panels using 6x dowels (101351) and screws.

Step 7: Secure Top Panel

Secure the top panel to the side panels using 6x cam locks (113434) and screws.

Step 8: Attach Back Panel

Position the cabinet upright. Attach the back panel to the rear of the cabinet using screws (e.g., 319503). Ensure the cabinet is square before fully securing.

Step 9: Secure Top Panel

Secure the top panel to the side panels with screws (e.g., 319503).

Step 10: Secure Top Panel

Secure the top panel to the side panels with screws (e.g., 319503).

Step 11: Attach Cabinet Brackets

Attach the cabinet mounting brackets to the sides of the cabinet using 2x screws (e.g., 10036383).

Step 12: Attach Back Panel

Attach the back panel to the rear of the cabinet using 25x screws (e.g., 319503).

Step 13: Prepare for Wall Mounting

Attach the wall mounting brackets to the cabinet using 2x parts (10039571).

Step 14: Wall Mounting

Attach the wall mounting hardware to the cabinet. Ensure correct orientation and secure with screws. Then, position the cabinet against the wall and mark the wall for drilling. Secure the cabinet to the wall using appropriate wall fixings (not included).

Step 15: Mount Cabinet on Wall Brackets

Slide the cabinet onto the wall-mounted brackets, ensuring it is securely attached.

Step 16: Install Shelf Supports

Install shelf supports into the pre-drilled holes on the inside of the cabinet using 2x parts (10046633).

Step 17: Install Shelf Supports

Install shelf supports using 6x parts (100347) and screws.

Step 18: Adjust Shelf Height

Adjust the height of the shelves by moving the shelf supports to the desired positions.

Step 19: Insert Shelves

Place the shelves onto the installed shelf supports.

Step 20: Final Top Panel Securing

Secure the top panel to the cabinet using screws (e.g., 109594).

Step 21: Final Top Panel Securing

Secure the top panel to the cabinet using screws (e.g., 109594).

Step 22: Drill Top Panel

Drill pilot holes into the top panel using a 5mm drill bit for final securing.

Step 23: Final Securing

Secure the top panel to the cabinet using screws (e.g., 130421).

Step 24: Final Back Panel Attachment

Attach the back panel to the rear of the cabinet, ensuring it is flush and square.