UTILITECH 12-Inch Battery-Powered Rechargeable LED Undercabinet Light

Preparation and Assembly

Before beginning assembly, ensure all parts are present by comparing them with the package contents and hardware lists. Do not assemble if any part is missing or damaged.

Estimated Assembly Time: 10 minutes

Tools Required (Not Included):

• Marking device or sharp object (for marking mounting positions)
• Screwdriver (implied for mounting screws)

Package Contents

• A: 12-Inch LED Undercabinet Light
• CC: USB Charging Cord
• DD: Remote Control

Hardware Contents

• AA: Screws (x2)
• BB: Sticker Mounting Pads (x2)

Installation Overview

Step 1: Mounting Preparation

For surface mounting, mark the desired positions (A1, A2) for the light on the mounting surface using a marking device or sharp object. Once marked, screw the mounting screws (AA) into place.

Step 2: Attaching the Light

Position the light fixture over the pre-installed screw heads. Push the light onto the screw heads, then slide it into a secured position.

Operation

Light Switch (on fixture)

• ON: Turns the light on. Default light color is Daylight.
• AUTO: Activates motion sensor mode. The light operates only in dark or low-light areas. It turns on automatically when motion is detected and turns off automatically after approximately 30 seconds of no motion. The sensor range is 2.5 m - 5 m.
• OFF: Turns the light off and conserves battery power.

Charging Indicator Light

• RED: Indicates the light is being charged.
• GREEN: Indicates the light is fully charged.

Remote Control Functions

Before first use, pull out the plastic tab from the bottom of the remote control.

• Power: ON, OFF, AUTO (motion sensor mode).
• Brightness: Adjust brightness levels. Default brightness is 100%.
• Color Temperature (CCT): Select from various color temperatures (e.g., 2700K, 3000K, 4000K, 5000K, 6500K).
• Timer: Set the light to turn off automatically after 1, 5, 15, or 30 minutes.

Troubleshooting

Care and Maintenance

Clean the fixture using a soft, damp or dry cloth. Never spray liquid cleaner or water directly onto the light or LED.

Warranty

This product is guaranteed against defects in materials or workmanship for two (2) years from the date of purchase. The warranty is non-transferable and applies only to the original owner. Proof of purchase is required for repair or replacement. This warranty does not cover normal wear of parts or damage resulting from misuse, including but not limited to: washing, use in extreme weather, opening the product, remodeling, or using incorrect voltage. This warranty is valid only if the product was purchased through an authorized reseller.

Safety Information

Please read and understand this entire manual before attempting to assemble, operate, or install the product.

• ⚠️ WARNING:
• Do not install the lighting near flammable liquids or gas.
• Turn power off before installation or removing the LED light.
• Verify the voltage before installing the bulb to ensure it is correct.
• Do not disassemble or modify the LED light for any purpose.
• Do not use the LED light with dimmers.
• Discontinue use if the product is damaged.
• Suitable for use in damp locations (covered locations, not exposed to water).
• To prevent permanent eye damage, do not look directly at the LED lights.
• This device is not intended for use with emergency exits or emergency lighting.
• Do not alter or disassemble any parts of the fixture; it is completely enclosed and contains no user-serviceable parts.