Häfele Lighting Tunable White LED Light Strip

Safety and Usage Instructions

⚠️ Important Safety Information:

• To prevent hazards, if the outer flexible cable of this light is damaged, it must only be replaced by the manufacturer, its service representative, or a comparable specialist.
• The light source of this light must only be replaced by the manufacturer, a service technician engaged by the manufacturer, or a person with comparable qualifications.
• For operation, use only safety-tested constant-voltage drivers according to EN 61347-1 that provide a safety extra-low voltage (SELV) of Uout = 12 or 24 V=. Refer to the light's type plate for specific voltage.
• The total lead length between the constant-voltage driver and the light must not exceed 10 meters, including any lead already present on the light.
• The conductor cross-section of the lead between the constant voltage power supply unit and the light plug must be at least 0.75 mm².
• This light contains a light source with energy efficiency class G.

Technical Specifications

Installation Guide

The following steps describe the general installation process. Refer to specific diagrams for detailed visual guidance.

Step 1: Preparation and Mounting

This step involves preparing the mounting surface and attaching the light strip.

• A hole of approximately 8 mm diameter may need to be drilled for cable management or mounting points.
• The light strip is shown being fitted into a profile or onto a surface. This may involve clips, screws, or adhesive.
• Ensure the light strip is securely positioned before proceeding.

Step 2: Electrical Connection

Connect the light strip to a suitable power supply unit.

• Use a constant-voltage power supply unit compatible with 12 V or 24 V= output.
• Connect the power supply to the mains input (100-240V~).
• Connect the power supply output to the light strip's input.
• The presence of a Bluetooth symbol suggests potential wireless control capabilities, requiring connection to a compatible Bluetooth receiver or driver.

Step 3: Finalizing Installation

Complete the installation by securing all connections and the light strip itself.

• Ensure all electrical connections are properly made and insulated.
• Secure the light strip in its final mounting position.

Product Information and Trademarks

This product is designed for tunable white lighting applications.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. Any use of these marks by Häfele SE & Co. KG is under license. Other trademarks and trade names are those of their respective owners.

Note: Product specifications are subject to alteration.

Markings: CE, IP20 rated.