GOTRAX GXL Folding Electric Scooter
User Manual
Congratulations On Your Purchase!
This user manual will help you assemble and operate your new electric scooter. Be sure to read ALL OF THE INFORMATION in this manual before riding.
NOTE TO ALL RIDERS UNDER 18 YEARS OF AGE: It's very important that you get parental permission before riding your electric scooter.
ℹ️ Don't Ride Until You Read This:
- ⛑️ ALWAYS wear a helmet when riding your electric scooter.
- ? Make sure your scooter has a full battery before taking it out to ride.
- ⚖️ Always be aware of local road laws, and follow them.
- ? Do not ride the scooter under the influence of drugs or alcohol.
- ? Always respect pedestrians.
- ?️ Do not ride under wet conditions. The scooter may slide from under your feet causing injury. Wet conditions may damage the electronics and void the warranty.
⚠️ Warning Message
- Avoid water: The scooter is not waterproof. Electronics may be damaged by water, and water damage is not covered by warranty. Riding in wet conditions is dangerous and may result in injury.
- Abuse: Physical damage due to negligent care and extreme riding is not covered.
- Whenever you ride the Gotrax scooter, you risk severe injury or even death from loss of control, collisions, and falls. Use caution and ride at your own risk.
- Do not modify the product from the manufacturer's original design.
- Keep hands and all body parts away from moving parts while operating the scooter.
- Before riding: Ensure the scooter is operating correctly before each use.
- Before riding: Check that the braking system is functioning properly and all safety labels are understood.
- Before riding: Ensure all axle guards, chain guards, or other covers supplied by the manufacturer are in place and in serviceable condition.
- Before riding: Check that the tires are in good condition, properly inflated, and have sufficient tread remaining.
- Never exceed the 220 lb (100 kg) maximum load rating.
- The electric scooter should never be used by children under the age of 13.
- Maximum Speed: Your electric scooter has a maximum speed of 15.5 mph.
? Unpack
You should find each of these items in your box:
- Electric Scooter
- Console & Handlebars
- Approved Power Adapter / Charging Unit
- Allen Wrench
- Screws
- Tire Pump Extender
- Safety Pin
Remove all packaging material, then inspect each item for any accidental damage that may have occurred during shipping.
? Get To Know Your Scooter
The electric scooter comes partially assembled.
- Headlight: Located at the front of the handlebars.
- Tiller: The vertical steering column.
- Hub Motor: Integrated into the front wheel.
- Accelerator (right thumb throttle): Controls speed.
- Console: Displays speed, battery life, and gear.
- Charger Port: Located on the tiller for charging the battery.
- Hook: Used for folding the scooter.
- Brake (left thumb throttle): Controls braking.
- Folding System: Mechanism for folding the scooter.
- Rear Brake: Foot-activated brake on the rear fender.
- Fender Buckle: Secures the folded scooter.
- Rear Reflector: Located on the rear fender for visibility.
- Disc Brake: Integrated into the rear wheel.
- Kickstand: Allows the scooter to stand upright when not in use.
?️ Assemble Your Scooter
1. Unfold Scooter & Lock in Upright Position
Press down on the rear fender, separate the folding hook and fender buckle, then lift the tiller upright. Once the scooter is locked in the upright position, verify by gently trying to fold.
2. Loosen Screws & Detach Cover
Use the Allen wrench to loosen the screws located at the hook and detach. Once you've removed the hook and screws, make sure to remove the cover from the top of the tiller.
3. Place Console into Tiller & Reattach
Place the console into the top of the tiller. Once the console is attached, use the Allen wrench to attach the hook back to the tiller with the two screws.
? Charge Your Scooter
Before using the scooter, you must fully charge the battery.
- Open the rubber charging port cover.
- Insert the charging plug into the port.
- The charger box will have a green light when fully charged and a red light when charging.
- When you are done charging, be sure to cover the charging port to keep it clear of dust and debris.
- Charging Time: 4 hours
Charging Requirement: Make sure to charge your scooter in conditions that do not exceed 104 degrees Fahrenheit (40 degrees Celsius) or go below 32 degrees Fahrenheit (0 degrees Celsius).
⚙️ Scooter Console Functions
- To power the scooter on: Press and hold the red button for 1 second.
- To power the scooter off: Press and hold the red button for 5 seconds.
- To power the headlight on or off: Press the red button for 1 second while the scooter is powered on.
- To change between 1st and 2nd gear: Press the red button for 2 seconds. The display screen on the console will switch from the number 1 (1st gear) to the number 2 (2nd gear).
The console on the Scooter displays speed in MPH, Battery life, and what gear the scooter is currently in.
? Riding Tips
- You will want to start riding your scooter with one foot on the platform and one foot on the ground. Use your foot on the ground to push off and at the same time, press the throttle button to begin movement.
- Press the brake-throttle to slow down or stop. For quicker stopping, step on the rear fender foot brake.
- The scooter performs best when on a smooth surface, e.g., carparks, smooth roads, footpaths, & bike lanes.
- Always clean your scooter (wheels, platform, etc.); it's a machine and it needs to be maintained.
- Do not press the throttle while walking with the scooter beside you.
- Be aware of the terrain you are riding on; watch out for curbs and obstacles!
- Use the red button to change between gears as you would on a bike, cycling through them according to the terrain and elevation. First gear provides more torque for going uphill; second gear offers more speed for straightaways.
- Cruise Control: To activate cruise control, press the right-hand throttle down for 10 seconds. To deactivate, press either the right-hand throttle or brake button.
- CAUTION: The left paddle control on the console operates the motor's Electro-Magnetic brake. This brake is energized by the motor's operation and will not be 100% effective until the motor has been in operation for 30 seconds.
↔️ Putting Your Scooter Away/Folding
Before folding the scooter, make sure that the scooter is powered off and remove the safety pin. Pull the tiller towards the back wheel, as shown in the figures. Insert the hook on the tiller into the loop on the rear fender buckle. You may hear a click, which indicates that you were successful in folding and locking the scooter.
?️ Maintenance & Repair
If you regularly clean and maintain your electric scooter, it will extend its life.
Cleaning and storage:
If the scooter is dirty, wipe it clean with a soft damp cloth. DO NOT use alcohol, gasoline, kerosene, or other corrosive chemical solvents to clean the scooter, as it can severely damage the appearance and structure. Do not use a pressure washer, as it may also damage the electronics.
Brake Adjustments & Service:
If you notice you need brake adjustments or any service on your scooter, contact the GOTRAX customer service team. Do not repair your scooter yourself, as this can void your warranty and risk damaging the scooter.
Tires:
If you notice that the tire pressure is low, please fill to the recommended PSI on the side of the tire. Recommended PSI: 50
Storage:
When you're not using your scooter, store it in a dry and cool location. Avoid storing your scooter outdoors because sun exposure can damage its appearance and may cause wear on the life of the battery and tires.
Tightening the Tiller:
If you notice that the tiller is loose or wiggles while riding, you can tighten the screws. Open the plastic cover and use the Allen wrench to tighten the screws.
? Safety Lock Instructions
1. Unfolding:
Lift the tiller in the upright position and insert the safety lock. Rotate the safety lock clockwise to tighten the safety lock before you ride!
2. Folding:
Rotate the Safety Lock counterclockwise to pull out the safety lock. Fold the scooter and then insert the safety lock and rotate clockwise to lock the safety lock again.
Detail: The hole for the safety lock is located next to the red lever on the bottom of the scooter. An arrow points to the Safety Pin. Insert the Safety Pin and twist it into the hole and secure it firmly in place.
? Battery Information
Only use the approved GOTRAX power adapter to charge your scooter; others may cause a risk of fire & equipment damage.
Improper disposal of used batteries may seriously pollute the environment. Please comply with local disposal regulations.
Make sure to store your scooter and power adapter in conditions that do not exceed 122 degrees Fahrenheit (50 degrees Celsius) or go below -4 degrees Fahrenheit (-20 degrees Celsius).
Warning - Risk of Fire: No User Serviceable Parts. Prolonged exposure to UV Rays, Rain, and the Elements may damage enclosed materials. Store indoors when not in use.
? Troubleshooting
GOTRAX frequently updates user manuals online at gotrax.com and reserves the right to update and change manuals online.
Please contact the GOTRAX customer service team if you are experiencing problems or need more detailed information. They can be reached at gotrax.com.
Warranty
For warranty information, please visit us at www.gotrax.com.
