Step 1: Attach Base Feet
Attach the 6 base feet to the underside of the main bottom panel using screws.
Important Safety Warning
WARNING! Furniture tip-over can cause serious or fatal crushing injuries. To prevent this, the furniture MUST be secured to the wall using the provided wall attachment device(s).
Screws and wall plugs are not included. Use screws and plugs suitable for your specific wall type. If unsure, consult a professional. Follow all instructions carefully.
(This warning is provided in multiple languages in the original document.)
Parts and Hardware
The following components and hardware are included:
- Main furniture panels (bottom, sides, top, back panels)
- Internal dividers/shelves
- Base feet (6x)
- Wall mounting brackets (3x)
- Cable management clips
- Various screws (e.g., 12x, 4x, 6x, 8x, 1x)
- Cam locks and dowels
- Allen key (1x)
- Specific internal securing fittings
(Refer to the original diagrams for specific part identification and quantities.)
Assembly Steps
Step 2: Assemble Main Frame
Connect the side panels to the bottom panel using screws and cam lock fittings. Attach the wall mounting brackets to the rear of the side panels.
Step 3: Install Internal Dividers
Insert the vertical and horizontal internal dividers into their designated slots. Secure them using the appropriate fittings (e.g., cam locks, dowels).
Step 4: Attach Top Panel
Place the top panel onto the assembled unit and secure it with fittings.
Step 5: Insert Back Panels
Slide the back panels into the grooves on the rear of the unit.
Step 6: Secure Internal Components & Cable Management
Install any remaining internal securing fittings. Route cables through the unit using the provided clips and openings.
Step 7: Attach Long Support Bar
Attach the long metal support bar to the unit as indicated in the diagrams.
Step 8: Final Unit Adjustments
Make any necessary adjustments, such as leveling the feet, to ensure the unit is stable.
Step 9: Wall Mounting Preparation
Position the unit against the wall. Mark the wall through the pre-attached wall brackets. Drill holes in the wall suitable for your wall type. Insert appropriate wall plugs (not included).
Step 10: Secure Unit to Wall
Screw through the wall brackets into the wall plugs to firmly secure the unit to the wall. This is critical for preventing tip-over.
Step 11: Final Checks
Confirm all connections are tight and the unit is safely and securely mounted to the wall.
