TONSTAD Chair Assembly Instructions

Parts and Tools

Assembly Steps

1. Step 1: Attach Leg Mounting Plates

   Place the seat base upside down. Attach the leg mounting plates to the designated positions on the seat base using the Allen key (100003) and screws (152548). Ensure the plates are oriented correctly as shown in the diagram. Use two screws per plate. The diagram also indicates that small circular pieces (washers or feet) should be attached to the seat base first.

   Note: Ensure correct orientation of the mounting plates. ❌ indicates incorrect placement.

2. Step 2: Attach Legs

   Attach the four chair legs to the mounting plates. Use the Allen key (100003) and screws (152548). Secure each leg with two screws.

3. Step 3: Attach Seat Cushion

   Turn the chair frame upright. Place the seat cushion onto the frame. Secure the cushion using the Allen key (100003) and three bolts (10123849).

4. Step 4: Place Chair Upright

   Carefully turn the assembled chair upright onto its legs.

5. Step 5: Apply Seat Cover

   Take the seat cover and place it over the seat cushion and backrest of the chair.

6. Step 6: Adjust Seat Cover

   Smooth out the seat cover, ensuring it fits snugly and evenly over the chair. Arrows indicate adjusting the fabric.

7. Step 7: Secure Seat Cover

   Tuck the edges of the seat cover underneath the seat frame to secure it in place. The close-up diagram shows the process of tucking the fabric.