Kichler 45887BK Lighting Fixture Installation Guide

Safety Precautions

CAUTION – RISK OF SHOCK

Disconnect Power at the main circuit breaker panel or main fusebox before starting and during the installation.

WARNING

This fixture is intended for installation in accordance with the National Electrical Code (NEC) and all local code specifications. If you are not familiar with code requirements, installation by a certified electrician is recommended.

Cleaning

Always be certain that electric current is turned off before cleaning.

Only a soft damp cloth should be used. Harsh cleaning products may damage the finish.

Installation Steps

1. Find the appropriate threaded holes on mounting strap [1] that align with hole distance in canopy [2]. Thread mounting screws [3] into threaded holes starting from the outlet box [4] side.
2. Attach mounting strap to outlet box with strap mounting screws [5]. Mounting strap can be adjusted to suit position of fixture.
3. Grounding instructions:
   • Illustration A: On fixtures where mounting strap is provided with a hole and two raised dimples, wrap ground wire from outlet box around green ground screw, and thread into hole.
   • Illustration B: On fixtures where a cupped washer is provided, put ground wire from outlet box under cupped washer and green ground screw and thread screw into hole in mounting strap.
   • If fixture is provided with ground wire, connect fixture ground wire to outlet box ground wire with wire connector after following the above steps. Never connect ground wire to black or white power supply wires.
4. Make wire connections. Reference the chart below for correct connections and wire accordingly.

   Connect Black or Red Supply Wire to:	Connect White Supply Wire to:
   Black	White
   *Parallel cord (round & smooth)	*Parallel cord (square & ridged)
   Clear, Brown, Gold or Black without Tracer	Clear, Brown, Gold or Black with Tracer
   Insulated wire (other than green) with copper conductor	Insulated wire (other than green) with silver conductor

   Note: When parallel wire (SPT 1 & SPT 2) are used, the neutral wire is square shaped or ridged and the other wire will be round in shape or smooth (See illustration).

   Neutral Wire

5. Push fixture to wall carefully passing mounting screws with holes in canopy. NOTE: Make sure all wires are inside canopy and do not get pinched between wall and canopy of fixture.
6. Use the lock washers [10] and then the knobs [6] to secure fixture to wall. Tighten to secure.
7. Carefully raise glass [7] to the fixture. Slip the smaller opening over the socket [8] and fit the glass against the socket.
8. Thread the socket ring [9] onto the socket. Tighten socket ring to secure glass in place DO NOT OVER TIGHTEN.
9. Insert recommended bulb (not supplied).
10. Repeat steps 7-9 for remaining sockets.