Baby Trend Nursery Center - Model PY86800
Instruction Manual
Thank you for choosing Baby Trend. Please read all instructions carefully before assembly and use. Keep these instructions for future reference.
Parts List
Before assembly, verify you have all the parts listed below for this model.
- 1x Playard (fully assembled)
- 1x Mattress
- 1x Bassinet with metal support tubes
- 1x Canopy
- 1x Changing table
- 2x Long Curved Bar
- 2x Short Bar with Connector Knob
- 1x Music Center (with vibration)
- 1x Travel / Storage Bag
- 1x Parent Organizer*
- 3x Toy Animal**
*Toys and mobile may vary. **Type and quantity may vary.
Safety Warnings
WARNING: NEVER LEAVE INFANT IN PRODUCT WITH SIDES DOWN. Infant may roll into space between pad and loose mesh side causing suffocation.
WARNING: INFANTS CAN SUFFOCATE:
- In gaps between a mattress too small or too thick and product sides.
- On soft bedding. Never add a mattress, pillow, comforter, or padding. Use only the mattress provided by manufacturer. Never use a water mattress with this product.
WARNING: Failure to follow these warnings and the instructions could result in serious injury or death.
- Always provide supervision. When used for playing, NEVER leave child unattended.
- To reduce the risk of SIDS, place infants on their back to sleep, unless advised otherwise by a physician.
- NEVER use plastic shipping bags or other plastic film as mattress covers; they can cause suffocation.
- NEVER use this product if any parts are loose, missing, broken, or torn. Contact Baby Trend Customer Service at 1-800-328-7363 for replacement parts.
- Strings can cause strangulation! NEVER place items with a string around a child's neck. NEVER suspend strings over playard or attach strings to toys.
- Discontinue use when child can climb out, reaches 35 in. (890 mm), or weighs 30 lbs. (14 kgs), whichever comes first.
- When child can pull to standing, remove bumper pads, large toys, or other objects that could serve as steps for climbing out.
- NEVER place product near a window where cords from blinds or drapes can strangle a child.
Maintenance and Cleaning Instructions: Use mild soap and warm water. DO NOT USE BLEACH. DO NOT MACHINE WASH.
Assembly Instructions
Assembling the Playard
- Unzip the bag and remove the playard frame. Undo fasten straps and set the mattress aside. Do not push the center down yet.
- Ensure all four (4) top rails are fully erected before lowering the center. Pull up one rail at a time, holding both sides, and pull sharply upwards. Do not pull from the middle where the center latch release is located. Ensure both tubes latch securely and each rail is rigid.
- Once all four top rails are locked, push down on the center handle. The center mechanism will rotate 90 degrees clockwise and lock in place. Test each top rail by pushing down slightly to confirm it is rigid and secure.
- Place the mattress on the playard floor with the padded side facing up.
- Insert the hook and loop fastener straps located on the underside of the mattress through the slots in the floor of each end of the playard. Fasten the straps to the underside of the playard floor to prevent the mattress from moving.
Folding the Playard
- To operate the brakes on the wheels, press down on the brake levers. To release, lift upward on the lever.
- Release the hook and loop fastener holding the mattress. Do not unlock top rails yet; the center of the floor must be raised before top rails will unlock. Rotate the center handle counter-clockwise 90 degrees and raise the center as high as the top rails. Gather the legs and wheels towards the center.
- Locate the rail latch release in the center and bottom side of each rail. Squeeze the lever with two hands until the rail releases the two tubes, then push down. If a rail does not release completely, DO NOT FORCE. Lift the center of the floor higher. Both tubes must be released for the top rail to fold.
- Gather the four corners and center all together tightly. Wrap the mattress around the playard frame with the padded side facing inward.
- Secure the hook and loop fastener by feeding them through the loops on the mattress end and folding them back onto themselves. Place the folded playard into the carry bag.
Assembling the Bassinet
- Connect opposing mattress support tubes that are attached to the bottom of the bassinet. Ensure tubes are connected before placing the mattress.
- Position the bassinet over and down into the fully assembled playard. Secure by pushing down firmly on each plastic support clip until snapped into place.
- Place the mattress into the bassinet with the padded side facing upward. Fasten tabs underneath the mattress to secure it.
To Remove Bassinet
Remove mattress and canopy. Disconnect opposing mattress support tubes. Unsnap all clips and lift the bassinet.
Assembling the Canopy
- Open the canopy. Adjust the opening at the top by aligning the inner center strap with the two outer straps. Ensure straps are aligned correctly so the canopy fits the playard.
- Position the canopy in the center of the playard. Attach each side by pressing canopy clips onto the center of the top rails. Attach the other end using the two buttons or hook and loop fasteners near each corner.
To Remove Canopy
Unsnap the canopy and pull upward from the sides of the playard.
Assembling the Changing Table
- Connect the two (2) Long Curved Bars together.
- Insert the assembled curved bars into the changing table fabric, sliding them around the inside sleeve.
- Attach the two (2) Short Bars to each end of the Long Curved Bar, ensuring knobs face down and in the same direction.
- Insert connector knob prongs into holes on both corners of the playard. Turn connector knobs counter-clockwise to lock.
- Flip the changing table over onto the playard. Snap the two (2) buttons on the flap down onto the playard.
To Secure the Changing Table to the Playard
When the changing table is flipped up, secure it to the playard frame using the provided hook and loop fastener.
- Locate the hook and loop fastener on the bottom of the changing table and on the inside of the playard side rails.
- Flip the changing table into its upper position.
- Secure the changing table to the playard frame by fastening the hook and loop fasteners on the underside of the changing table to the side rails of the playard frame.
To Use Changing Table Restraint System
- Place child on the changing table, ensuring hands and arms are clear of the restraint. Bring the restraint around the child's waist and clip the buckle ends together. Tighten strap until snug, but DO NOT OVER TIGHTEN.
To Remove Changing Table
- Flip the changing table to the outside of the playard. Unsnap the fabric flap. Twist connector knobs clockwise to unlock. Remove the changing table. Disconnect short bars from the curved bar by pressing snap buttons and pulling apart. Remove curved bar from the sleeve.
Parent Organizer Assembly
- Parent Organizer: Position hooks so the hooked end faces the rear. Press hook firmly into the slot until it snaps into place.
- Parent Organizer/Diaper Stacker: Connect by sliding the two connecting clips over an open portion of the top rail of the playard. Note: Can only be installed on open sides where clips attach easily without interfering with other features.
Mobile Assembly
- Attach the mobile (a) to the tri-shaped arm (b). Align slots on both pieces and gently press together.
- Attach the mobile to the canopy using the hook and loop fastener, connecting straps through the hole in the top of the mobile housing.
Music Center
WARNING: Keep batteries out of reach. Do not mix old and new batteries, or different battery types (alkaline, carbon-zinc, rechargeable nickel-cadmium). Remove batteries before long-term storage.
- The Music Center is designed to attach to the playard's long rail.
- The Music Center requires 4 AA batteries. Unscrew the battery door, pull it outward, install batteries as shown, and re-secure the door.
Operation
MUSIC: Press the MUSIC button to play music and change songs.
NATURE SOUNDS: Press the NATURE button to play nature sounds and change sounds.
SLEEP MUSIC: Press the SLEEP button to play sleep music and change songs.
VOLUME CONTROL: Use the two buttons to control the unit's volume.
VIBRATION: Press the VIBRATION button once to activate vibration. Press again for a faster speed. Press again to reduce speed.
NIGHT LIGHT: Press the NIGHT LIGHT button to turn on the night light.
Regulatory and Warranty Information
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: it must not cause harmful interference, and it must accept any interference received.
WARNING: Changes or modifications not expressly approved could void the user's authority to operate the equipment.
Canada ICES-003 Statement
This Class B digital apparatus complies with Industry Canada Standard ICES-003.
Warranty
Baby Trend® warrants workmanship defects for the first 180 days of purchase. Misuse, abuse, improper assembly, or alterations void the warranty. Contact Baby Trend Customer Service at 1-800-328-7363 for assistance. Warranty is valid in North America only.
