Important Safety Information
⚠️IMPORTANT: Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
Tools Required
The following tools are typically needed for installation:
- Phillips head screwdriver ?
- Flathead screwdriver ?
- Pliers ?
Smart Home Integration
ℹ️ This luminaire is compatible with IKEA Home smart systems. Follow pairing instructions for smart functionality.
Assembly Instructions
Step 1: Prepare Lamp Body
Illustration shows attaching two mounting brackets to the main lamp body using small pins.
Step 2: Secure Lamp Body
Illustration shows securing the main lamp body with two (x2) screws, tightened with a screwdriver ?.
Step 3: Install Internal Component
Illustration shows inserting an internal component (likely a driver or control module) into the lamp body and connecting wires.
Step 4: Mount Suspension Bracket
Illustration shows mounting the suspension bracket to the ceiling with two (x2) screws. An information icon ℹ️ is shown next to a diagram indicating the correct screw type (long, pointed) and a crossed-out diagram showing an incorrect screw type (short, blunt). Ensure the correct screws are used for ceiling mounting.
Step 5: Attach Suspension Wires
Illustration shows attaching suspension wires to the main lamp body. Wires are inserted into clips. A close-up shows a wire being guided into a clip ↪️.
Step 6: Connect Suspension Wires
Illustration shows connecting the suspension wires to the lamp body. Two (x2) wires are inserted into clips on the lamp body.
Step 7: Connect Power Cable
Illustration shows connecting the main power cable. Wires are inserted into a terminal block, and a cover is secured.
Step 8: Secure Wiring Compartment
Illustration shows securing the internal wiring compartment cover with four (x4) screws.
Step 9: Secure Component
Illustration shows securing another internal component with two (x2) screws.
Step 10: Prepare Power Cable
Illustration shows preparing the power cable wires. Approximately 10 mm (25/64 inches) of insulation is stripped from the ends of the wires.
Step 11: Connect Power Wires
Illustration shows connecting the power wires to the terminal block. The Neutral (N) wire and Line (L) wire are inserted into the correct terminals. Diagrams show the N and L markings on the terminal block.
Step 12: Secure Terminal Block Cover
Illustration shows securing the terminal block cover with two (x2) screws.
Step 13: Install Final Cover
Illustration shows installing the final cover with four (x4) screws.
Step 14: Attach Lamp Body to Suspension
Illustration shows attaching the main lamp body to the suspension wires; it clicks into place.
Step 15: Adjust Suspension Height
Illustration shows adjusting suspension height by tightening two (x2) clips to secure the wires.
Step 16: Final Positioning and Securing
ℹ️ Information: Lamp position can be adjusted horizontally (max 5 cm / 2 inches). Final securing action shown with 'Click!' confirmation.
Step 17: Smart Home Pairing
ℹ️ Smart Home Pairing: Press and hold the reset button for more than 10 seconds (⏳ > 10 s) to pair. A reset button ? is shown on a component.
