PILSKOTT Smart Lighting System
IKEA PILSKOTT
Getting Started
Connect your PILSKOTT product to the mains power supply or plug the power cable into a wall socket.
If you have the TRÅDFRI gateway or DIRIGERA hub: Download the IKEA Home smart app from the App Store or Google Play. The app will guide you through the installation process for your product and other devices.
Controlling Your Lighting
Once connected to the mains, the lighting can be turned ON/OFF using the main switch or a foot switch. For dimming capabilities or to connect your product to other IKEA Home smart products, a separate steering device (e.g., a remote control) is required.
The steering device needs to be paired with your wireless product. If you have multiple wireless products, each can be paired with the same steering device, allowing the entire system to be turned ON/OFF or dimmed simultaneously.
Pairing a Steering Device to Your Product
- Connect at least one (1) product to the mains before starting the pairing process. Ensure the mains power is turned ON.
- Locate the pairing symbol on the LED driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
- Press and hold the pairing button on the steering device for at least 10 seconds. A steady red LED light will illuminate on the steering device. The product will then dim and flash once to indicate successful pairing with the steering device.
Factory Resetting Your Driver
If the product is unresponsive or you wish to un-pair it from a steering device, a factory reset may be necessary. To force a factory reset, carefully push and hold the small button (marked RESET) on the LED driver enclosure using a pen tip with slight pressure.
A factory reset can also be performed by toggling the main switch 6 times.
Important Information
- The product is designed for indoor use only.
- Operating temperatures should be between 5°C and 45°C (41°F to 113°F).
- To prevent overheating, do not expose the product to direct sunlight or place it near any heat sources.
- The declared radio range between the unit and the steering device is measured in open air.
- Building materials and the placement of units can affect the wireless connectivity range.
Care Instructions
To clean the unit, wipe it with a dry, soft cloth. Never use abrasive cleaners or chemical solvents, as they can damage the product.
Product Servicing
Do not attempt to repair this product yourself. Opening or removing parts may expose you to dangerous voltage points or other risks.
Keep these instructions for future reference.
Technical Data
PILSKOTT Unit
- Type: G2015 PILSKOTT
- Input: 100-120 VAC, 50/60 Hz, 14.5W
- Max lumen output: 700lm
Power Supply Unit
- Type: ICPSLC24-30-IL44-1
- Input: 100-120 VAC, 50/60 Hz, 0.51A
- Output: 24.0V DC
- Max total load: 1.25 A, 30.0 W
- Radio range: 10 m in open air
- Operating frequency: 2400-2483.5MHz
- Output power: 12 dBm
Usage: Indoor use only
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
RF Exposure Information & Compliance
According to RF exposure regulations, under normal operating conditions, the end user should maintain a distance of at least 20 cm from the device.
This device complies with Part 15 of the FCC Rules. It also contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, users are encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
License Rights and Limitations
No rights or licenses, express or implied, are granted to use third-party devices in combination with these products in a wireless mesh network, or to use third-party services to access, monitor, or control these products via the internet or another external wide area network.
For use pursuant to U.S. Patent Nos.: US 6,914,893, US 7,697,492, US 8,964,708
Waste Disposal
The crossed-out wheeled bin symbol indicates that the product should not be disposed of as household waste. It must be recycled according to local environmental regulations for waste disposal. By separating products with this symbol, you contribute to reducing the volume of waste sent to incinerators or landfills and minimizing negative impacts on human health and the environment. For more information, please contact your IKEA store.
