V720 WiFi Camera Setup and Usage Guide
Thank you for purchasing this product. Please read this manual carefully before using it and keep it in a safe place.
Disclaimer: Please comply with the relevant laws and regulations of the country where use is permitted. Disassembly is strictly prohibited. This product is strictly prohibited for any illegal purposes. Shenzhen Yidian International Digital Co., Ltd. is not responsible for any legal consequences arising from the illegal use of this product.
Client Downloading
Please scan the QR code below to download and install the "v720" app. Alternatively, search for "V720" in your mobile phone's app store to download and install.
Adding a Device
- Open the "v720" app. Click the top-right corner of the page and tap "+" to start the binding process.
- Select or enter the WiFi account you wish to use and enter the password.
- Turn on and reset the device according to the on-page guidance. The blue indicator light will flash quickly.
- Wait until the device is bound successfully. The blue indicator light will remain steadily lit. (Tip: Ensure the network is unblocked and the camera is powered on normally during connection. The blue indicator flashes quickly when connecting. After successful connection, the indicator light will be steady blue.)
AP Mode
On your phone, open the WiFi hotspot starting with "NAX_". Return to the "v720" app and refresh the dropdown list. When the device appears, it signifies a successful short-range mode connection.
Notes
- The applicable working temperature for this product is -10°C to 50°C. Do not use this product in environments with excessively high or low temperatures.
- This product is a precision electronic device. Avoid using it in excessively humid environments or where water may enter the product.
- To optimize performance, avoid positioning the lens close to reflective surfaces such as glass or white walls, as this may cause uneven image brightness (bright near, dark far, or washed out).
- Ensure this product is installed within Wi-Fi signal coverage. Place it in a location with the best possible Wi-Fi signal and try to install it away from microwave ovens or other devices that may interfere with the signal.
Information to User (FCC Compliance)
Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement: To maintain compliance with FCC's RF Exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.
