JBC CLM Manual Tip Cleaner
Model: CLM
Reference: CL8499
Manufacturer: JBC
Website: www.jbctools.com
Packing List
The following items are included:
- Manual Tip Cleaner (Ref. CL8499) - 1 unit
- Sponge (Ref. S0354) - 1 unit
- Brass Wool (Ref. CL6210) - 1 unit
- Manual (Ref. 0028694) - 1 unit
Features
Select the option to suit your needs and improve the thermal transfer of the tip.
Brass Wool (Ref. CL6210)
A very effective cleaning method. It leaves a small layer of solder on the tip to prevent oxidation between cleaning and rewetting.
Sponge (Ref. S0354)
The least harmful cleaning method. Keep the sponge damp with distilled water when working to avoid tip wear.
Splashguard (Ref. 0017576)
It prevents splashing of solder particles when using the brass wool.
Antisplash Membrane (Ref. 0017574)
Prevents splashing and keeps the work area clean.
ESD Safe Tip Wiper (Ref. CL0240)
A temperature-resistant receptacle lets the operator remove excess solder by gentle tapping or wiping.
Tapping: Tap to remove excess solder.
Wiping: Use the slots to remove remaining particles.
Non-Slip Base
No need to hold the base while cleaning tips.
If the tip is very dirty, JBC recommends first cleaning it with the wiper to remove excess solder and then with the brass wool.
Replacement Procedures
Wiper Replacement
First pull the wiper out.
Then insert the new one.
[Diagram: Showing removal of old wiper and insertion of new wiper]
Wool/Brush Replacement
Open the splashguard and take it off.
Depending on the component used, replace the brass wool (1) or brush (2) for a new one.
[Diagram: Showing splashguard removal and replacement of brass wool or brush]
Membrane Replacement
Loosen the screw and remove the screw and washer.
Then take out the fixing clamp.
Finally, the membrane. Replace the membrane for a new one.
Once the new membrane is positioned, place all the components back again and tighten the screw.
[Diagram: Showing screw removal, fixing clamp removal, membrane replacement, and reassembly]
Specifications
Product: CLM Manual Tip Cleaner
Reference: CL8499
| Total Net Weight: | 877 g / 1.93 lb |
| Package Dimensions / Weight (Lx W x H): | 130 x 100 x 98 mm / 936 g (5.12 x 3.92 x 3.86 in / 2.06 lb) |
Complies with CE standards. ESD Safe.
Warranty
JBC's 2-year warranty covers this equipment against all manufacturing defects, including the replacement of defective parts and labor. Warranty does not cover product wear or misuse. In order for the warranty to be valid, equipment must be returned, postage paid, to the dealer where it was purchased.
Environmental and Compliance Information
This product should not be thrown in the garbage. In accordance with the European directive 2012/19/EU, electronic equipment at the end of its life must be collected and returned to an authorized recycling facility.
Compliance Marks: CE, EAC
[WEEE symbol - do not dispose in garbage]
