Fresh 'n Rebel Clam ANC Headphones
Product Codes: 3HP400DP | 3HP400SG | 3HP400IG | 3HP400PB
Buttons
- 1. On/off: Power button
- 2. Bluetooth pairing: Bluetooth connection button
- 3. Volume up/down - Next song: Volume and track control
- 4. Active Noise Cancelling: ANC switch
- 5. Power LED: Indicator for power status
- 6. ANC LED: Indicator for ANC status
Getting Started
Follow these steps to begin using your Clam ANC headphones:
- Charge the headphones fully.
- Turn on Bluetooth on your device and press and hold the Bluetooth button on the headphones until the LED blinks.
- Select "CLAM ANC" from the list of available Bluetooth devices on your mobile device.
- Flip the ANC switch to activate or deactivate Active Noise Cancelling.
- Enjoy your music in silence.
(Diagrams in the original document illustrate these steps visually.)
Button Behavior
ANC Buttons
- Slide Down: Active Noise Cancelling Off
- Slide Up: Active Noise Cancelling On. Note: ANC must be manually switched off when powering down the headphones. If the switch is left 'on' and headphones are powered on again, ANC will automatically enable.
Power Button
- Press 2 Sec: Turn On
- Press 5 Sec: Turn On + Pairing Mode
- Press 5 Sec: Turn Off
- Single Click: Play / Pause / Answer Call / End Call
- Press 3 Sec: Decline Incoming Call
Volume Buttons
- Button (Volume Down / Previous Song)
- Single Click: Volume Down
- Press 2 Sec: Previous Song
+ Button (Volume Up / Next Song)
- Single Click: Volume Up
- Press 2 Sec: Next Song
LED Behavior
ANC LED
- ANC Enabled: Solid white light
- ANC Disabled: Off
Power LED
- Power On: Solid white light
- Playback: Solid white light
- Bluetooth: Blinking white light (0.5 seconds on / 0.5 seconds off)
- Charging: Solid red light
- Fully Charged: Solid green light
- Low Battery: Blinking red light (0.25 seconds on / 0.25 seconds off)
Listen Up! (FAQ)
What is the ANC feature exactly?
ANC stands for Active Noise Cancelling. It means the Clam Headphones mute ambient noise by listening to it and filtering it out, ensuring you can enjoy your music to the fullest.
I switched off the headphones but ANC is still activated!
Yes, the ANC feature has its own switch. ANC also works when you are not listening to music, for example, when you want to sleep on an airplane. Remember to switch off ANC when not in use to conserve battery life.
What is the length of the cable?
The Clam Headphones come with a 100cm detachable fabric cable.
Need help with warranty?
The standard 2-year store warranty is valid upon presentation of proof of purchase (original invoice with date and product code). Please contact the shop where you bought your Fresh 'n Rebel product to claim warranty. For further questions, contact helpme@freshnrebel.com.
Important Safety Instructions
WARNING!
- Always follow all instructions and warnings closely.
- Do not place near open flames, such as candles.
- Dispose of batteries according to environmental regulations.
- Do not expose the battery to excessive heat (sunshine, fire, etc.).
- CAUTION: Danger of explosion if battery is replaced incorrectly. Replace only with the same or equivalent type.
- Using the product in tropical or moderate climates does not affect the device.
Warranty & Limitations
Fresh 'n Rebel warrants the product against defects in material and workmanship for 2 years from the date of purchase under normal usage. The warranty does not cover accidental damage, wear and tear, incidental loss, or use beyond the manual's instructions.
Product Specifications
| Feature | Specification |
|---|---|
| Form factor | Circumaural |
| Cup type | Closed |
| Headphones technology | Dynamic |
| Connectivity | Wireless Bluetooth |
| Drivers | 40 mm |
| Frequency response | 20Hz-20KHz |
| Battery type | Lithium Ion |
| Battery capacity | 600 mAh |
| Playtime (50% volume) | 35 hours |
| Playtime with ANC activated (50% volume) | 30 hours |
| Charging time | 3 hours |
| Impedance | 32 Ohm |
| Harmonic distortion | 1% |
| Microphone | Omnidirectional, 100-8000 Hz |
| Bluetooth profiles | A2DP, AVRCP, HFP, HSP |
| Connections | 3.5mm, Micro USB |
| Buttons | Power, BT, Play/Pause, Volume +/-, ANC on/off |
| Operating frequency band | 2402-2480 MHz |
| Maximum radio-frequency power transmitted | 8.3 dBm / 6.76 mW |
