Fresh 'n Rebel Clam ANC Headphones
Product Codes: 3HP400DP | 3HP400SG | 3HP400IG | 3HP400PB
What is the ANC Feature?
ANC stands for Active Noise Cancelling. This feature allows the Clam Headphones to mute surrounding noise by listening to and filtering it out, ensuring you can enjoy your music to the fullest.
Let's Get Started
Follow these simple steps to begin using your Clam ANC headphones:
- Charge the headphones fully.
- Turn on Bluetooth by pressing and holding the button until the LED blinks.
- Select the "Clam ANC" headphones on your mobile device.
- Flip the ANC switch to the desired position (on/off).
- Enjoy your music in silence.
Diagrams illustrate the button locations, smartphone Bluetooth pairing process, and the ANC switch.
Button Behavior
ANC Buttons
- Slide Down: Active Noise Cancelling off.
- Slide Up: Active Noise Cancelling on. Note: You must manually turn off ANC when powering off the headphones. If the switch remains in the 'on' position, ANC will automatically enable when the headphones are turned back on.
Power Button
- Press 2 Sec: Turn on.
- Press 5 Sec: Turn on + pairing mode.
- Press 5 Sec: Turn off.
- Single Click: Play / pause / pick up call / hang up call.
- Press 3 Sec: Decline incoming call.
Volume Buttons
- - Button (Single Click): Volume down.
- - Button (Press 2 Sec): Previous song.
- + Button (Single Click): Volume up.
- + Button (Press 2 Sec): Next song.
LED Behavior
ANC LED
- ANC Enabled: Solid white.
- ANC Disabled: Off.
Power LED
- Power On: Solid white.
- Playback: Solid white.
- Bluetooth: Blinking white (0.5 sec on / 0.5 sec off).
- Charging: Solid red.
- Fully Charged: Solid green.
- Low Battery: Blinking red (0.25 sec on / 0.25 sec off).
Product Specifications
Feature | Specification |
---|---|
Form factor | Circumaural |
Cup type | Closed |
Headphones technology | Dynamic |
Connectivity | Wireless Bluetooth |
Drivers | 40 mm |
Frequency response | 20Hz-20KHz |
Battery type | Lithium Ion |
Battery capacity | 600 mAh |
Playtime (50% volume) | 35 hours |
Playtime with ANC activated (50% volume) | 30 hours |
Charging time | 3 hours |
Impedance | 32 Ohm |
Harmonic distortion | 1% |
Microphone | Omnidirectional, 100-8000 Hz |
Bluetooth profiles | A2DP, AVRCP, HFP, HSP |
Connections | 3.5mm, Micro USB |
Buttons | Power, BT, Play/Pause, Volume +/-, ANC on/off |
Important Safety Instructions
WARNING!
The following safety guidelines are designed to help you get the maximum performance from your Fresh 'n Rebel products safely and ensure reliable operation:
- Always follow all instructions and warnings closely.
- Do not place near open flames, such as candles.
- Dispose of batteries according to environmental regulations.
- Do not expose the battery to excessive heat (sunshine, fire, etc.).
- CAUTION: Danger of explosion if the battery is replaced incorrectly. Replace only with the same or an equivalent type.
- Using the product in tropical or moderate climates does not affect the device.
Warranty & Limitations
Fresh 'n Rebel warrants this product against defects in material and workmanship under normal usage for a period of 2 years from the date of purchase. During this period, defective products may be offered for repair or replacement at the store where the product was bought. The warranty does not cover accidental damage, wear and tear, incidental loss, or use beyond the instructions in the user manual.
Operating frequency band: 2402 to 2480 MHz
Maximum radio-frequency power transmitted: 8.3 dBm / 6.76 mW
Need Help?
If your question is not answered here, Fresh 'n Rebel is ready to assist you. Contact us via email at: helpme@freshnrebel.com