LILLVIKEN Sink Trap Assembly Instructions

Step 1: Assemble Trap Inlet

Connect the main trap body (Part 148962) to the angled inlet pipe. An audible "CLICK!" indicates a secure connection.

[Diagram: Shows the main trap body (148962) connecting to an angled pipe. An arrow indicates the connection point, and the text "CLICK!" is visible.]

Step 2: Attach Trap to Sink

Insert the assembled trap unit from under the sink into the sink's drain opening.

[Diagram: Shows the sink from the top and the trap unit being inserted from below into the sink's drain hole.]

Step 3: Secure Trap to Sink

From below the sink, thread and tighten the nut (Part 148977) onto the sink drain fitting to secure the trap assembly.

[Diagram: Shows the underside of the sink with the trap unit. A hand is shown tightening a nut (148977) onto the drain fitting.]

Step 4: Cut Flexible Hose (if needed)

If the flexible drain hose is too long, measure and cut it to the required length using a hacksaw. Ensure the cut is clean.

[Diagram: Shows a hacksaw cutting a flexible pipe. A magnified view shows the cut end of the pipe and a piece of tape being applied.]

Step 5: Mount Bracket

Prepare the mounting bracket. Attach the bracket to the wall using the provided bolt (Part 148975). Ensure it is securely fastened.

[Diagram: Shows a bracket being prepared. A magnified view shows the bracket being screwed into the wall with a tool.]

Step 6: Install Sink Strainer

Insert the sink strainer assembly (Part 195565) into the sink drain opening from above. Ensure the sealing ring is correctly positioned. Tighten the strainer assembly from below.

[Diagram: Shows the sink drain from above with the strainer being inserted. A magnified view shows a hand pressing the strainer down. Another view shows tightening from below.]

Step 7: Connect Drain Hose to Trap

Connect one end of the flexible drain hose to the outlet of the sink trap.

[Diagram: Shows the sink trap outlet and the flexible hose being connected.]

Step 8: Connect Drain Hose to Wall Outlet

Connect the other end of the flexible drain hose to the wall's drain pipe. Ensure proper alignment and secure connections.

[Diagram: Shows the flexible hose being connected to a pipe in the wall.]

Step 9: Check Angles and Connections

Ensure all pipe connections are secure and that the trap has the correct slope for drainage. Avoid sharp bends or kinks in the hose.

[Diagram: Shows multiple views of pipe connections. Some configurations are marked with a red cross (❌) indicating incorrect angles or placement, while correct connections are implied. An informational icon (ⓘ) may be present.]

Step 10: Test for Leaks

Run water into the sink and check all connections for leaks. The water should drain freely through the trap.

[Diagram: Shows two sink configurations. The first shows water draining correctly through the trap (✔️). The second shows water leaking from an incorrect connection, marked with a red cross (❌).]

Step 11: Clean Trap (Maintenance)

Periodically, the trap may need cleaning. Remove any debris from the trap outlet and dispose of it in a trash can. Reattach any removed parts securely.

[Diagram: Shows debris being removed from the trap outlet and placed in a trash can. A magnified view shows a cap being removed from the trap outlet and then reattached with an audible "Click!".]

Step 12: Secure Flexible Hose

Use the provided mounting bracket to secure the flexible drain hose to the wall, ensuring it is held in place and does not sag excessively.

[Diagram: Shows the flexible hose being secured to the wall using a bracket and screws. A magnified view illustrates the bracket attachment.]

Step 13: Install Sink Strainer Cap (if applicable)

If your model includes a separate cap for the strainer, insert it as shown.

[Diagram: Shows the sink strainer assembly with a cap being inserted.]