PETLIBRO CAPSULE Fountain

⚠️ Safety Precautions

• Dispose of all packaging materials properly. Keep polybags away from children and pets as they could cause suffocation.
• Do NOT allow children to play with, in, or around the pet water fountain.
• To avoid injury, please keep close supervision when the appliance is used near children.
• Do NOT use the water fountain with pets unable to reach the water tray or with any physical disability.
• Do NOT place any foreign object in the water tank.
• Do NOT disassemble the pet fountain other than components instructed in this User Manual.
• Do NOT use the pet fountain for anything other than its intended use.
• Only use attachments recommended or sold by the manufacturer. Using unrecommended attachments may cause an unsafe condition. Do NOT modify the pet fountain.
• Do NOT operate any appliance if the unit is malfunctioning or damaged. Do not attempt repairs yourself. Contact customer service immediately for further instructions.
• Be sure to disconnect the power supply for safety when the appliance is not in use.
• Please disconnect the power supply before maintaining and cleaning the machine.
• Always unplug the appliance when not in use, or before putting on/taking off parts and before cleaning.
• The power adapter and wire plug must not be flooded during cleaning.
• This product is for indoor use only.
• This product is not allowed to run without water.
• Never pull the electrical power cord to remove the plug from the wall outlet.
• If the plug of this device gets wet, turn off the electricity of that wall outlet. Do NOT attempt to unplug.
• Check the device after installation. Do NOT plug in if there is water on the contact points or plug.
• To avoid tripping, always position the power cord out of the way of foot traffic.
• Do not use the appliance in the bathroom.
• Change the filter every 2 weeks or when the flow rate has noticeably reduced. For two or more cats, you may need to replace filters more regularly if they become blocked.

Warranty

• 2-year warranty
• Lifetime support

For guidance on product use and warranty extension, please contact PETLIBRO after-sales staff via email: support@petlibro.com. For any questions related to orders, please contact the seller through the shopping platform.

Product Overview

The PETLIBRO CAPSULE Fountain is designed to provide fresh, circulating water for your pets. It features a multi-layer filtration system and a quiet pump.

Components:

• 1) Spout: The part from which water flows.
• 2) Water Outlet: Where water exits the main body.
• 3) Water Tray: The main basin holding the water.
• 4) Filter: A replaceable filter for water purification.
• 5) Filter Tray: Holds the filter in place.

The fountain also includes a water pipe, water pump with power cord, foam filter, and charger.

How to Use

1. Filter Preparation: Soak the filter in a clean bowl for 5 minutes, then rinse it thoroughly with tap water. Ensure the filter is fully soaked before turning on the fountain to prevent uneven water flow and spillage. Do not soak the filter in the water tank if there is surface dust.

2. Pump Installation: Position the pump according to the bottom slot shape in the water tank. Press the pump down firmly to ensure the suction cups adhere to the base. Insert the power cord into the designated slot. The pump must be fixed in the correct position.

3. Soft Plug Installation: To prevent water leakage and secure the power cord, align the cord slot when installing the soft plug.

4. Silicone Pipe and Water: Install the silicone pipe onto the pump. Add water to the tank, ensuring the water level is between the MIN and MAX marks. The pump may fail if it runs dry.

5. Filter Tray and Filter: Install the filter tray and place the filter onto it. Press down firmly to ensure the pipe outlet is correctly positioned.

6. Water Tray Installation: Install the water tray. The installation of the spout depends on your pet's drinking preference.

7. Connect Power: Connect the power adapter to the fountain and plug it into a power outlet.

Care Instructions

• Replace the filter and foam filter every 2 weeks.
• Clean the pump and fountain every 2 weeks.
• To extend the pump's life, add water before starting the machine.

How to Clean the Pump:

1. Remove the pump cover and impeller cover in sequence. The foam filter is located within the pump cover; replace it every 2 weeks.
2. Remove the impeller using the brush hook.
3. Clean the parts with water using the brush. The brush can also be used to clean the spout. It is recommended to clean the spout every 2 weeks.

Troubleshooting

Specifications

PLWF002 (ABS)

PLWF002 (ABS & Stainless Steel)