PETLIBRO Capsule Automatic Pet Water Fountain User Manual

Safety Precautions

Warning

• Dispose of all packaging materials properly. Keep polybags away from children and pets to prevent suffocation.
• Do not allow children to play with, in, or around the pet water fountain.
• Keep close supervision when the appliance is used near children to avoid injury.
• Do not use the water fountain with pets unable to reach the water tray or with physical disabilities.
• Do not place any foreign object in the water tank.
• Do not disassemble the pet fountain except for components instructed in this User Manual.
• Do not use the pet fountain for anything other than its intended use.
• Only use attachments recommended or sold by the manufacturer. Use of unrecommended attachments may cause an unsafe condition. Do not modify the pet fountain.
• Do not operate any appliance if the unit is malfunctioning or damaged. Do not attempt repairs yourself. Contact customer service for instructions.
• Disconnect the power supply for safety when the appliance is not in use.
• Disconnect the power supply before maintaining and cleaning the machine.
• Always unplug the appliance when not in use, or before putting on/taking off parts and before cleaning.
• The power adapter and wire plug must not be flooded during cleaning.
• This product is for indoor use only.
• This product is not allowed to run without water.
• Never pull the electrical power cord to remove the plug from the wall outlet.
• If the plug gets wet, turn off the electricity of that wall outlet. Do not attempt to unplug.
• Check the device after installation. Do not plug in if there is water on the contact points or plug.
• To avoid tripping, position the power cord out of the way of foot traffic.
• Do not use the appliance in the bathroom.
• Change the filter every 2 weeks or when the flow rate noticeably reduces. For two or more cats, replace filters more regularly if they become blocked.

Caution

• Do not allow pets to chew on or swallow any parts. If concerned about the power cord, purchase a cord conduit (a hard-plastic protector) at any hardware store.
• If an extension cord is necessary, use one with a proper rating.
• Do not install or store the pet water fountain where it will be exposed to weather or temperatures below 0°C / 40°F.
• Read and observe all important notices on the pet water fountain and in the packaging.

FCC Compliance and Radiation Exposure

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Radiation Exposure Statement: To maintain compliance with FCC's RF Exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm from your body.

Warranty and Support

• 1-year warranty
• Lifetime support

For guidance on product use and warranty extension, please contact PETLIBRO customer support via email: support@petlibro.com.

For questions related to orders, please contact the seller through the shopping platform.

Product Overview

The PETLIBRO Capsule Automatic Pet Water Fountain consists of the following parts:

Components:

• 1) Spout: The part where water is dispensed.
• 2) Water Outlet: The opening for water flow.
• 3) Water Tray: The basin that holds the water for pets to drink from.
• 4) Filter: A component that filters the water.
• 5) Filter Tray: A holder for the filter.
• 6) Water Pipe: Connects the pump to the spout.
• 7) Water pump with power cord: Circulates and dispenses water.
• 8) Foam Filter: An additional filter, often part of the pump assembly.
• 9) Charger: Powers the water pump.
• 10) Soft Plug: Seals the cord entry point to prevent leaks.
• 11) Cord Slot: Guides the power cord.
• 12) Water Tank: The main reservoir for the water.

How to Use

1. Soak the filter: Place the filter in a clean bowl with water for 5 minutes, then rinse it thoroughly with tap water.

   Notes: The filter must be fully soaked before the fountain is turned on; otherwise, water may not flow smoothly and could cause spillage. Do not soak the filter in the water tank itself to avoid surface dust contamination.

2. Position the pump: Align the pump with the bottom slot shape. Press the pump to secure the suction cups tightly. Place the power cord into the cord slot.

   Note: Ensure the pump is fixed in the correct position within the tank.

3. Install the soft plug: To prevent water leakage and secure the power cord, align the cord slot when installing the soft plug.
4. Connect pipe and add water: Install the silicone pipe onto the pump. Add water to the tank, ensuring the level is between the MIN and MAX indicators.

   Note: The pump will fail if it runs dry.

5. Install filter tray and filter: Place the filter tray into position and then place the filter onto the filter tray. Press down firmly to ensure the pipe outlet is correctly seated.
6. Install water tray: Place the water tray. The spout can be installed or omitted based on your pet's drinking preference.
7. Connect power adapter: Plug the power adapter into a power source.

Care Instructions

• Replace the filter and foam filter every 2 weeks.
• Clean the pump and fountain every 2 weeks.
• To extend the life of the pump, always ensure there is water before starting the machine.

How to clean the pump:

1. Remove the pump cover and impeller cover.
2. Remove the impeller using the brush hook.
3. Use the brush to clean the parts with water.

Tip: The brush can also be used to clean the spout. It is recommended to clean the spout every 2 weeks.

Note: The foam filter is located within the pump cover; change the foam filter every 2 weeks.

Troubleshooting

Specifications

PLWF002 (ABS)

PLWF002 (ABS & Stainless Steel)