Pelonis 23" Ceramic Tower Heater

Important Safety Instructions

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1. Read all instructions before using the heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, always use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater or return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
6. Do not use the heater outdoors.
7. This heater is not intended for use in bathrooms, laundry areas, and similar moist indoor locations. Never locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic areas and where it will not be tripped over.
9. CAUTION: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. Doing so could result in an electric shock hazard.
10. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working.
11. CAUTION: It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified electrician to replace loose or worn outlets.
12. To disconnect the heater, first turn controls to off, then remove plug from outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
17. CAUTION: Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or reloadable power tap (outlet/power strip).
18. The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns.
19. Disposal of oil contained within should be in accordance with applicable regional, national, and local laws and regulations.
20. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT AND FULLY INSERT.

SAVE THESE INSTRUCTIONS

Part Figure

The heater consists of the following parts:

• Control panel
• Display screen
• Front cover
• Grille
• Rear cover
• Base

The control panel includes:

• Display area
• Oscillation button
• Timer button
• '-' button
• '+' button
• Function button
• ON/OFF button

Operating Instructions

Check before turning on the machine

1. Check if the power wire is in good condition.
2. The product adopts 120V AC power supply. Before use, please confirm if the rated current of the power socket meets the local requirements with a safe grounding device; otherwise, please replace it with a qualified socket.

Start the machine

Plug the unit into a grounded 120V outlet. The power light "⚡" will illuminate. Press the ON/OFF key (or press the ON/OFF key of the remote controller) to start. The machine supplies air at high power after starting, and the digital screen displays "HI".

Function setting

Repeatedly press the "Function" key to cycle through the heater modes: High Gear - Low Gear - ECO Mode - High Gear.

Temperature setting

In ECO mode, press "+" or "" to set the temperature between 5-35°C. When the room temperature exceeds the set temperature by 2°C, the machine stops working and enters standby mode. When the temperature drops below the set temperature, the machine starts heating again.

Timing function

Timing stop: When the heater is on, press the TIMER key to enter the timing stop state (0-8 hours). Press "+" to increase the time and "-" to decrease it.

Timing start: When the heater is in standby mode, press the TIMER key to enter the reservation start mode (0-8 hours). Press "+" to increase the start time and "-" to decrease it.

Oscillation function

While the heater is operating, press the "Oscillation" key to activate the oscillation function. Pressing the button again turns it off. When the heater stops heating, the oscillation function also stops.

Safety Protections

Temperature sensor short circuit, open circuit protection function

If the temperature sensor experiences a short circuit or open circuit in any mode, the digital screen will display "E1" or "E2" and flicker. Any key operation will be invalid, and the buzzer will sound 10 times.

Safety protection (Overheat)

When the room temperature (TH) exceeds 50°C, all system outputs will close. The digital screen will display "FF" and flash once per second. No key operation will work; only powering down will exit this protection.

Tip-over switch

As a safety measure, the unit will shut off automatically if it is knocked over. If this occurs, turn the heater off, stand it back in an upright position, and then switch it back on.

ECO energy saving function

Selecting the ECO energy saving mode allows the heater to adjust its operation based on the ambient temperature and the set temperature, optimizing energy consumption.

Remote Controller

The remote controller functions are similar to the main control panel.

Control range of remote controller

The remote controller can be used normally within 5 meters in front of the product and within a 30-degree angle to the left and right.

Use manganese or alkaline batteries of type "AAA" (1.5V). Do not use non-rechargeable batteries.

Remote control buttons:

• ON/OFF button: Turns the heater on or off.
• Function button: Cycles through heating modes (High, Low, ECO).
• '+' button: Increases temperature or timer setting.
• '-' button: Decreases temperature or timer setting.
• Timing button: Sets the timer for delayed start or stop.
• Turn on/off the Oscillation button: Activates or deactivates the oscillation function.
• ECO button: Selects the ECO energy-saving mode.

Main Technology Specifications

Power supply: AC 120V ~ 60Hz

Troubleshooting

If the product does not operate or does not operate properly, check the following:

If the problem persists or is not listed, contact customer support.

Cleaning and Storage

It is recommended that the heater be cleaned at least once during the operating season for optimal performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Save the original box for off-season storage.

• Turn the heater "OFF", unplug it, and wait for it to cool down.
• Use a dry cloth to clean only the external surfaces of the heater.
• Do not use any cleaning agents or detergents.
• Never immerse the heater in water.
• Pack the heater in the original carton and store it in a cool, dry place.

READ AND SAVE THESE INSTRUCTIONS

Service & Support

For warranty claims or service, contact Pelonis:

Toll-free: 1-866-646-4332

Email: canada@midea.com

For your records, staple your sales receipt to this manual and record the following:

DATE OF PURCHASE:
PLACE OF PURCHASE:
[STAPLE SALES RECEIPT HERE]

NOTE: PROOF OF PURCHASE IS REQUIRED FOR A WARRANTY CLAIM.

PRINTED IN CHINA

One Year Limited Warranty

Please read all instructions before attempting to use this product.

PELONIS warrants to the original purchaser that each new Pelonis Product shall be free of defects in material and workmanship for a period of one (1) year from the date of original purchase. This one (1) year warranty is limited to the heating elements, motor, and electric control circuit board.

In the event of malfunctions or failure of your Pelonis Product, deliver or send the heater, postage prepaid, along with PROOF OF PURCHASE, within the warranty period of one (1) year, to PELONIS. PELONIS reserves the right to inspect the claimed defective part or parts to determine if the defect or malfunction complaint is covered by this warranty. PELONIS shall, within sixty (60) days after receipt of the product, at its option, repair and/or replace the defective part or parts free of charge. This warranty shall only cover defects arising from normal usage. PELONIS assumes no responsibility whatsoever if the Product should fail during the warranty period by reason of:

• Misuse, negligence, physical damage, or accidents.
• Lack of maintenance (see instructions for proper maintenance).
• Repair by any unauthorized party during the warranty period.
• Damage caused by connection to an improper input voltage (see specification label on your heater).

PELONIS makes no further warranties or representations, express or implied, except those contained herein. No representative or dealer is authorized to assume any other liability regarding the Product. The duration of the implied warranty granted under State law, including warranties of merchantability and fitness for a particular purpose, are limited in duration should the duration of the express warranty grant it hereunder. PELONIS shall in no event be liable for direct, indirect, special, or consequential damages.

Some states do not allow limitations on how long an implied warranty lasts, and/or the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights which vary from state to state.