Pelonis Digital Ceramic Tower Heater

Owner's Manual & Safety Instructions

Before using this product, please read this manual carefully and keep it for future reference. For additional support, please call customer service at 1-866-646-4332. The design and specifications are subject to change without prior notice for product improvement. Consult with your dealer or the manufacturer for details.

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, and hyperthermia, including the following:

⚠️ CAUTION

• Read all instructions before using the heater.
• Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. To do so could result in an electric shock hazard.
• It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified electrician to replace a loose or worn outlet.
• Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or reloadable power tap (outlet/power strip).
• TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT AND FULLY INSERT.

⚠️ WARNING

• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, always use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from the sides and rear.
• Always unplug the heater when not in use.
• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard the heater or return it to an authorized service facility for examination, electrical or mechanical adjustment, or repair.
• Do not use the heater outdoors.
• This heater is not intended for use in bathrooms, laundry areas, and similar moist indoor locations. Never locate the heater where it may fall into a bathtub or other water container.
• Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or appliances. Arrange the cord away from traffic areas and where it will not be tripped over.
• This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working.
• To disconnect the heater, first turn controls to off, then remove the plug from the outlet. Never pull by the cord.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on a soft surface, like a bed, where openings may become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
• The output of this heater may vary, and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns.
• Hyperthermia can result in death. Symptoms of hyperthermia include high body temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and rapid pulse. If you begin to experience symptoms related to hyperthermia, turn off the heater and seek medical attention.
• To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave the product running unattended in a confined space around infants, or individuals with reduced physical, sensory, or mental capabilities.

SAVE THESE INSTRUCTIONS

Specifications

Power Regulation Range

Product Overview

The diagram shows the main components of the Pelonis Digital Ceramic Tower Heater. The parts labeled are: Display screen, Control panel, Grille, Front cover, Rear cover, and Base.

Operation Instructions

Check Before Turning On The Machine

• Check if the power cord is in good condition.
• The product uses a 120V AC power supply. Before use, please confirm if the rated current of the power socket meets local requirements with a safe grounding device. If not, please replace it with a qualified socket.

Panel Operation & Display

The control panel features a digital display area showing temperature (e.g., 35°C) and mode indicators (e.g., ECO). Buttons are labeled numerically:

• 1. Function: Repeatedly press the “Function” key to cycle through modes: “high gear - low gear - ECO mode - fan only mode - high gear”.
• 2. Oscillation: Press the “Oscillation” key to activate the oscillation function. Pressing it again turns off oscillation. If the heater stops heating, the oscillation function will also stop.
• 3. ON/OFF: Plug the unit into a grounded 120V outlet. The power light will illuminate. Press the ON/OFF key (or the ON/OFF key on the remote controller) to start. The machine will supply air at high power, and the digital screen will display “HI”.
• 4. Timer: When the heater is on, press the TIMER key to enter the timing stop state (within 0-12 hours). Use the “+” key to increase the timing stop time and the “-” key to decrease it.
• 5. Adjustment: Press “+” or “-” to set the temperature value or timer. In ECO mode, use “+” or “-” to set the temperature within the range of 5-35°C. When the room temperature exceeds the set temperature by 2°C, the machine stops working and enters standby. When the temperature drops below the set temperature, the machine restarts heating.

Additional Functions

• Forced shutdown function: If the machine runs for 15 hours without any operation, it will automatically shut down.
• Temperature sensor short circuit, open circuit protection function: If the temperature sensor appears short-circuited or open-circuited in any mode, the digital screen will display “E1” or “E2” and flicker continuously. Any key operation will be invalid, and the buzzer will ring 10 times.
• Safety protection: When powered on, if the room temperature (TH) is above 50°C, the machine will shut off all output systems. The digital screen will show “FF” and flash once per second for 75 times. Pressing any key will not work; unplugging the unit is required to stop the protection.
• Tip-over switch: As a safety measure, the display area will show “P4”, and the unit will shut off automatically if it is knocked over. If this occurs, turn the heater off, stand it back up to a normal upright position, and then switch it back on.
• ECO energy saving function: Select the ECO energy saving mode and set the temperature. The heater will adjust its heating gear by comparing the ambient temperature and the set temperature.

Remote Control

The remote control offers functions similar to the main control panel. Its control range is up to 5 meters in front of the product, with a horizontal angle of 30 degrees to the left and right.

The remote control is black and rectangular. It has buttons for Oscillation, ON/OFF, Function, Temperature Increase, Temperature Decrease, and Timer. It uses AAA batteries.

NOTE

• Please use a manganese or alkaline battery of type “AAA” and do not use a non-recyclable battery.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.

Cleaning and Maintenance

It is recommended to clean the heater at least once during the operating season for optimal performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Save the box for off-season storage.

• Turn the heater “OFF”, unplug it, and wait for it to cool down.
• Use a dry cloth to clean only the external surfaces of the heater.
• Do not use any cleaning agents or detergents.
• Never immerse the heater in water.
• Pack the heater in its original carton and store it in a cool and dry place.
• Any other maintenance shall be performed by an authorized service provider.

⚠️ WARNING

This heater cannot achieve accurate temperature control of the environment and thus cannot be used as an insulation device for storage environments, items, animals, or plants.

Troubleshooting

If the product does not operate or does not operate properly, check the following list. If the cause is not listed, the product may have failed. In such cases, it is recommended to send the product to the dealer for treatment.

Service and Support

In the event of a warranty claim or if service is required for this product, please contact us:

Toll Free: 1-866-646-4332

For questions or comments, please write to:

Midea America (Canada) Corporation
215 Shields Ct Unit #2,
Markham, ON L3R 8V2

For your records, staple your sales receipt to this manual and record the following:

DATE OF PURCHASE: ____________________

PLACE OF PURCHASE: ____________________

(STAPLE SALES RECEIPT HERE)

NOTE: PROOF OF PURCHASE IS REQUIRED FOR ALL WARRANTY CLAIMS.

PRINTED IN CHINA

1 Year Limited Warranty

Midea America Corporation warrants to the original purchaser of retail that each new Ceramic Heater shall be free of defects in material and workmanship for a period of one (1) year from the date of original purchase. This one (1) year warranty is limited to the Motor and Electric Element.

In the event of malfunctions or failure of your Ceramic Heater, simply deliver or send the Ceramic Heater, postage prepaid, along with PROOF OF PURCHASE, within one (1) year, to Midea America Corporation. Midea America Corporation reserves the right to inspect the claimed defective part or parts to determine if the defect or malfunction complaint is covered by this warranty. Midea America Corporation shall, within sixty (60) days after receipt of the product, at its option, repair and/or replace the defective part or parts free of charge. This warranty shall only cover defects arising from normal usage.

Midea America Corporation assumes no responsibility whatsoever if the Ceramic Heater should fail during the warranty period by reason of:

• Misuse, negligence, physical damage, or accidents.
• Lack of maintenance (see instructions for proper maintenance).
• Repair by any unauthorized party during the warranty period.
• Damage caused by connection to an improper input voltage (see specification label on your Ceramic Heater).

Midea America Corporation makes no further warranties or representations, express or implied, except those contained herein. No representative or dealer is authorized to assume any other liability regarding the Ceramic Heater. The duration of implied warranties granted under State law, including warranties of merchantability and fitness for a particular purpose, are limited in duration to the duration of the express warranty granted hereunder. Midea America Corporation shall in no event be liable for direct, indirect, special, or consequential damages.

Some states do not allow limitations on how long an implied warranty lasts, and/or the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.