LEIRSUND Slatted Bed Base

Parts List

• 1x Allen key (100006)
• 12x Screw (100229)
• 2x Screw (109049)
• 2x Washer (100823)
• 12x Plastic support (139243)
• 1x Slatted bed base roll
• 15x Wooden slat
• 27x Wooden slat
• 6x Wooden slat
• 2x Side rail with chain
• 3x Support rail

Assembly Steps

1. Step 1: Attach side rails to support rails using screws (100229) and the Allen key (100006). Use 3 screws per connection.
2. Step 2: Ensure the correct orientation of the side rails. The image shows a check for correct assembly, with a red cross indicating incorrect placement.
3. Step 3: Unroll the slatted bed base and insert the wooden slats into the chain mechanism. Ensure slats are inserted correctly with the arrow indicating the direction of insertion.
4. Step 4: Continue inserting the wooden slats into the chain mechanism. Ensure slats are properly seated.
5. Step 5: Place the assembled slats onto the bed frame.
6. Step 6: Attach the plastic supports (139243) to the side rails. These are adjustable for firmness (HARD/SOFT).
7. Step 7: Insert the plastic supports onto the slats. Ensure they are correctly oriented.
8. Step 8: Continue attaching plastic supports to the remaining slats.
9. Step 9: Insert the remaining wooden slats into the chain mechanism.
10. Step 10: Continue inserting wooden slats.
11. Step 11: Insert the final set of wooden slats.
12. Step 12: Secure the end of the slatted base with screws (100229) and washers (100823).
13. Step 13: Attach the central support rail using screws (109049) and washers (100823).
14. Step 14: Adjust the firmness of the plastic supports by sliding them to the desired position (HARD or SOFT). The image shows a weight (kg/lb) indicating the effect of adjustment.

Important Notes:

• Ensure all parts are present before assembly.
• Follow the steps carefully to ensure correct assembly.
• Refer to the diagrams for visual guidance on each step.
• The plastic supports allow for adjustable firmness.